[PATCH v2 3/3] ARM: dts: enable GPIO-a for Broadcom NSP

[Florian Fainelli]

On 04/12/15 09:12, Yendapally Reddy Dhananjaya Reddy wrote:
> This enables the GPIO-a support for Broadcom NSP SoC
> 
> Signed-off-by: Yendapally Reddy Dhananjaya Reddy <yrdreddy at broadcom.com>

Finally applied to devicetree/next, since there was a bit of
restructuring with the addition of the ranges, please verify the results
look correct here:

https://github.com/Broadcom/stblinux/commit/018e4feb7584971b3dbda6daa6a8fef310cafbcb

> ---
>  arch/arm/boot/dts/bcm-nsp.dtsi | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/bcm-nsp.dtsi b/arch/arm/boot/dts/bcm-nsp.dtsi
> index 58aca27..148d79e 100644
> --- a/arch/arm/boot/dts/bcm-nsp.dtsi
> +++ b/arch/arm/boot/dts/bcm-nsp.dtsi
> @@ -116,4 +116,16 @@
>  			status = "disabled";
>  		};
>  	};
> +
> +	gpioa: gpio at 18000020 {
> +		compatible = "brcm,nsp-gpio-a";
> +		reg = <0x18000020 0x70>,
> +		      <0x1803f1c4 0x1c>;
> +		#gpio-cells = <2>;
> +		gpio-controller;
> +		ngpios = <32>;
> +		interrupt-controller;
> +		interrupts = <GIC_SPI 85 IRQ_TYPE_LEVEL_HIGH>;
> +		gpio-ranges = <&pinctrl 0 0 32>;
> +	};
>  };
> 


-- 
Florian