[PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx

[Sylvain Lemieux]

Hi Vladimir,

On Wed, 2016-02-10 at 02:19 +0200, Vladimir Zapolskiy wrote:
> Hi Sylvain,
> 
> On 09.02.2016 23:01, Sylvain Lemieux wrote:
> > Vladimir Zapolskiy <vz at ...> writes:
> >>
> >> This changeset adds common clock framework driver for NXP LPC32xx
> >> boards.
> > 
> > Just to let you know that we did some testing using this changeset;
> > I installed patches 4 to 7, 10 & 11 on top of 4.5-rc1.
> > 
> > I was able to run our software (SIC1 interrupt sources disable)
> > without any problem a custom LPC32xx board.
> 
> this is a known issue, and I hope it will be fixed in upstream in v4.6,
> the required changes in irqchip and gpiochip drivers were sent for
> review some time ago, a bit more work is needed to 
> 
I also tested the irqchip patches you sent previously;
I will send a separate e-mail with the information.

> Also 2-3 more clean-up changes in USB host and gadget drivers are done
> locally (no more need to configure clocks out of the common clock
> framework), but not yet submitted, will do it tomorrow.
> 
> > We did not get any problem with the clock signals we are using.
> > 
> 
> Thank you for testing, I'm going to add your Tested-by tag (if you
> don't mind) and submit a PR to ARM maintainers shortly.
> 
You can go ahead for the tag; please use slemieux at tycoint.com

> >> Vladimir Zapolskiy (11):
> >>   dt-bindings: clock: add description of LPC32xx clock controller
> >>   dt-bindings: clock: add description of LPC32xx USB clock controller
> >>   dt-bindings: clock: add NXP LPC32xx clock list for consumers
> >>   arm: dts: lpc32xx: add device nodes for external oscillators
> >>   arm: dts: lpc32xx: add clock controller device node
> >>   arm: dts: lpc32xx: add clock properties to device nodes
> >>   arm: dts: lpc32xx: add USB clock controller
> >>   clk: lpc18xx: add NXP specific common clock framework selection
> >>   clk: lpc32xx: add common clock framework driver
> >>   arm: lpc32xx: switch to common clock framework
> >>   arm: dts: lpc32xx: remove clock frequency property from UART device
> >>     nodes
> > 
> > 
> 
> With best wishes,
> Vladimir