[PATCH 00/11] clk: lpc32xx: add clock support for NXP LPC32xx

[Vladimir Zapolskiy]

Hi Sylvain,

On 09.02.2016 23:01, Sylvain Lemieux wrote:
> Vladimir Zapolskiy <vz at ...> writes:
>>
>> This changeset adds common clock framework driver for NXP LPC32xx
>> boards.
> 
> Hi Vladimir,
> 
> Just to let you know that we did some testing using this changeset;
> I installed patches 4 to 7, 10 & 11 on top of 4.5-rc1.
> 
> I was able to run our software (SIC1 interrupt sources disable)
> without any problem a custom LPC32xx board.

this is a known issue, and I hope it will be fixed in upstream in v4.6,
the required changes in irqchip and gpiochip drivers were sent for
review some time ago, a bit more work is needed to 

Also 2-3 more clean-up changes in USB host and gadget drivers are done
locally (no more need to configure clocks out of the common clock
framework), but not yet submitted, will do it tomorrow.

> We did not get any problem with the clock signals we are using.
> 

Thank you for testing, I'm going to add your Tested-by tag (if you
don't mind) and submit a PR to ARM maintainers shortly.

>> Vladimir Zapolskiy (11):
>>   dt-bindings: clock: add description of LPC32xx clock controller
>>   dt-bindings: clock: add description of LPC32xx USB clock controller
>>   dt-bindings: clock: add NXP LPC32xx clock list for consumers
>>   arm: dts: lpc32xx: add device nodes for external oscillators
>>   arm: dts: lpc32xx: add clock controller device node
>>   arm: dts: lpc32xx: add clock properties to device nodes
>>   arm: dts: lpc32xx: add USB clock controller
>>   clk: lpc18xx: add NXP specific common clock framework selection
>>   clk: lpc32xx: add common clock framework driver
>>   arm: lpc32xx: switch to common clock framework
>>   arm: dts: lpc32xx: remove clock frequency property from UART device
>>     nodes
> 
> 

With best wishes,
Vladimir