[PATCH v3 4/5] ARM: dts: sun8i-h3: Add R_PIO controller node to the dtsi

[Chen-Yu Tsai]

On Thu, Feb 4, 2016 at 7:33 AM, Krzysztof Adamski <k at japko.eu> wrote:
> Add the corresponding device node for R_PIO on H3 to the dtsi. Support
> for the controller was added in earlier commit.
>
> Signed-off-by: Krzysztof Adamski <k at japko.eu>
> ---
>  arch/arm/boot/dts/sun8i-h3.dtsi | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
>
> diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi
> index bb37f52..f618a95 100644
> --- a/arch/arm/boot/dts/sun8i-h3.dtsi
> +++ b/arch/arm/boot/dts/sun8i-h3.dtsi
> @@ -517,5 +517,17 @@
>                         compatible = "allwinner,sun6i-a31-clock-reset";
>                         #reset-cells = <1>;
>                 };
> +
> +               r_pio: pinctrl at 01f02c00 {
> +                       compatible = "allwinner,sun8i-h3-r-pinctrl";
> +                       reg = <0x01f02c00 0x400>;
> +                       interrupts = <GIC_SPI 45 IRQ_TYPE_LEVEL_HIGH>;
> +                       clocks = <&apb0_gates 0>;
> +                       resets = <&apb0_reset 0>;
> +                       gpio-controller;
> +                       #gpio-cells = <3>;
> +                       interrupt-controller;
> +                       #interrupt-cells = <2>;

This should be 3: bank number + pin number + flags.
The rest looks good.

(resent as my mail setup failed to deliver)

> +               };
>         };
>  };
> --
> 2.1.4
>