[resend v2: PATCH 1/2] dt-bindings: Document the hi3660 reset bindings

[Arnd Bergmann]

On Friday, December 2, 2016 8:21:33 AM CET zhangfei wrote:
> Hi, Arnd
> 
> On 2016年12月01日 20:05, Arnd Bergmann wrote:
> > On Thursday, December 1, 2016 8:48:40 AM CET Zhangfei Gao wrote:
> >> +               hisi,reset-bits = <0x20 0x8             /* 0: i2c0 */
> >> +                                  0x20 0x10            /* 1: i2c1 */
> >> +                                  0x20 0x20            /* 2: i2c2 */
> >> +                                  0x20 0x8000000>;     /* 3: i2c6 */
> >> +       };
> >> +
> >> +Specifying reset lines connected to IP modules
> >> +==============================================
> >> +example:
> >> +
> >> +        i2c0: i2c at ..... {
> >> +                ...
> >> +               resets = <&iomcu_rst 0>;
> >> +                ...
> >> +        };
> > I don't really like this approach, since now the information is
> > in two places. Why not put the data into the reset specifier
> > directly when it is used?
> Any example, still not understand.
> They are consumer and provider.

I mean in the i2c node, have

	i2c0: i2c at ..... {
		...
		resets = <&iomcu_rst 0x20 0x8>;
		...
	}

> > Also the format seems a little too close to the actual register
> > layout and could be a little more abstract, using bit numbers instead
> > of a bitmask and register numbers instead of offsets.
> We use bit numbers first.
> But in the developing process, we found several bits may be required for 
> one driver.
> And they may not be continuous as the bits may already be occupied.
> Directly using offset, we can set several bits together for simple, to 
> give more flexibility.
> So after discussion, we directly use offset.

Can you give an example for why this is needed? Is this different
from a device that has multiple reset lines?

	Arnd