[PATCH] ARM: dts: add PM8058 LEDs to the APQ8060 Dragonboard

[Jacek Anaszewski]

On 08/18/2016 03:10 PM, Linus Walleij wrote:
> On Wed, Aug 17, 2016 at 11:40 PM, Jacek Anaszewski
> <jacek.anaszewski at gmail.com> wrote:
>
>>> +                               led at 48 {
>>> +                                       /*
>>> +                                        * The keypad LED @0x48 is routed
>>> to
>>> +                                        * the sensor board where it is
>>> +                                        * connected to an infrared LED
>>> +                                        * SFH4650 (60mW, @850nm) next to
>>> the
>>> +                                        * ambient light and proximity
>>> sensor
>>> +                                        * Capella Microsystems CM3605.
>>> +                                        */
>>> +                                       compatible =
>>> "qcom,pm8058-keypad-led";
>>> +                                       reg = <0x48>;
>>> +                                       label = "proximity0";
>>
>>
>> In DT bindings documentation it was changed to "pm8050:white:keypad" to
>> adhere to the LED class device naming convention. I assume that having
>> it in this form is an omission here.
>
> Hm right. Given the usecase here, what do you say about naming
> it:
>
> "pm8058:infrared:proximitysensor"

Looks good.

-- 
Best regards,
Jacek Anaszewski