[PATCH v4 0/5] mtd: pxa3xx_nand: rework the timing setup

[Ezequiel Garcia]

On 22 October 2015 at 12:12, Thomas Petazzoni
<thomas.petazzoni at free-electrons.com> wrote:
> Hello Antoine,
>
> On Wed, 21 Oct 2015 10:28:59 +0200, Antoine Tenart wrote:
>
>> Antoine Tenart (5):
>>   mtd: pxa3xx: prepare allowing compile test
>>   mtd: nand: allow compile test of MTD_NAND_PXA3xx
>>   mtd: pxa3xx_nand: add helpers to setup the timings
>>   mtd: pxa3xx_nand: rework flash detection and timing setup
>>   mtd: pxa3xx_nand: clean up the pxa3xx timings
>
> I tested your series on Armada 375 DB, which uses the same pxa3xx
> driver, but with the Armada 370 variant.
>
> With the current Device Tree which has nand,keep-config to keep the
> timing configuration from the bootloader, I don't see any problem, so
> there is no regression introduced by your series, at least on this
> platform.
>
> However, when I remove nand,keep-config to use the ONFI timings from
> the NAND, then things work fine (I can mount a UBIFS root filesystem),
> but there is a weird:
>

Could you compare NAND throughput using keep-config (keeping
the bootloader timings) and without keep-config (with ONFI timings) ?

-- 
Ezequiel García, VanguardiaSur
www.vanguardiasur.com.ar