[RESEND PATCH v2 1/6] ARM: dts: Mark SDIO as non-removable in exynos5800-peach-pi
Javier Martinez Canillas
javier at osg.samsung.com
Wed Nov 18 05:23:49 PST 2015
The Exynos5800 Peach Pi Chromebook has a Marvell WiFi SDIO chip which
can't neither be removed nor be detected. But the node isn't marked
as non-removable and instead has the broken-cd DT property.
This causes the device to be removed when the system enters into a
suspend state and the following warnings is shown after a resume:
[ 181.944636] mmc2: error -2 during resume (card was removed?)
Also remove the card-detect-delay property that is not needed with
non-removable.
Signed-off-by: Javier Martinez Canillas <javier at osg.samsung.com>
Reviewed-by: Krzysztof Kozlowski <k.kozlowski at samsung.com>
Reviewed-by: Alim Akhtar <alim.akhtar at samsung.com>
---
arch/arm/boot/dts/exynos5800-peach-pi.dts | 3 +--
1 file changed, 1 insertion(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/exynos5800-peach-pi.dts b/arch/arm/boot/dts/exynos5800-peach-pi.dts
index 49a4f43e5ac2..ca3a467a585d 100644
--- a/arch/arm/boot/dts/exynos5800-peach-pi.dts
+++ b/arch/arm/boot/dts/exynos5800-peach-pi.dts
@@ -672,10 +672,9 @@
&mmc_1 {
status = "okay";
num-slots = <1>;
- broken-cd;
+ non-removable;
cap-sdio-irq;
keep-power-in-suspend;
- card-detect-delay = <200>;
clock-frequency = <400000000>;
samsung,dw-mshc-ciu-div = <1>;
samsung,dw-mshc-sdr-timing = <0 1>;
--
2.4.3
More information about the linux-arm-kernel
mailing list