[PATCH v5 3/3] ARM: dts: igep00x0: add wl18xx bindings

[Javier Martinez Canillas]

Hello Eliad,

On Wed, Mar 11, 2015 at 1:28 AM, Javier Martinez Canillas
<javier at dowhile0.org> wrote:
> On Mon, Mar 9, 2015 at 4:36 PM, Eliad Peller <eliad at wizery.com> wrote:
>> --- a/arch/arm/boot/dts/omap3-igep0020-rev-f.dts
>> +++ b/arch/arm/boot/dts/omap3-igep0020-rev-f.dts
>> @@ -42,4 +42,13 @@
>>         vmmc-supply = <&lbep5clwmc_wlen>;

Something I forgot to mention is that this vmmc-supply is a DT hack
since the WLAN SDIO chip needs a WL_EN signal to be asserted as a part
of the chip power sequencing.

But there wasn't a DT binding to describe that so most boards use the
same hack which is to define a fake fixed-regulator with an enable
GPIO just to toggle that pin.

But now the MMC subsystem has support for power sequence providers and
the pwrseq-simple driver
(Documentation/devicetree/bindings/mmc/mmc-pwrseq-simple.txt) has
support for reset GPIOs so you may want to change that as well.

In fact, the pwrseq-simple also has support for an external clock (and
can be extended to support more than one) so if the clocks are not
internal to the wl12xx, maybe these should be defined in the
pwrseq-simple dev node assuming that there is a clock driver for them.

Best regards,
Javier