[PATCH 03/17] phy: ti-pipe3: use *syscon* framework to set PCS value of the PHY

[Kishon Vijay Abraham I]

Hi,

On Wednesday 24 June 2015 04:04 PM, Roger Quadros wrote:
> On Tue, 23 Jun 2015 17:28:48 +0530
> Kishon Vijay Abraham I <kishon at ti.com> wrote:
> 
>> Deprecate using phy-omap-control driver to set PCS value of the PHY
>> and start using *syscon* framework to do the same.
>>
>> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
>> ---
>>   Documentation/devicetree/bindings/phy/ti-phy.txt |    2 ++
>>   drivers/phy/phy-ti-pipe3.c                       |   32 +++++++++++++++++++++-
>>   2 files changed, 33 insertions(+), 1 deletion(-)
>>
>> diff --git a/Documentation/devicetree/bindings/phy/ti-phy.txt b/Documentation/devicetree/bindings/phy/ti-phy.txt
>> index d3ad3bf..52c7a92 100644
>> --- a/Documentation/devicetree/bindings/phy/ti-phy.txt
>> +++ b/Documentation/devicetree/bindings/phy/ti-phy.txt
>> @@ -83,6 +83,8 @@ Optional properties:
>>    - syscon-pllreset: Handle to system control region that contains the
>>      CTRL_CORE_SMA_SW_0 register and register offset to the CTRL_CORE_SMA_SW_0
>>      register that contains the SATA_PLL_SOFT_RESET bit. Only valid for sata_phy.
>> + - syscon-pcs : phandle/offset pair. Phandle to the system control module and the
>> +   register offset to write the PCS delay value.
> 
> What is PCS?

IIRC physical coding subsystem.
> Is this valid only for PCIe? If yes we could mention it here.

This is introduced specifically for PCIe. But there are other PCS registers
with a different register map altogether for USB. I'm not sure if we will ever
have to do those settings.

Thanks
Kishon

> 
>>   
>>   Deprecated properties:
>>    - ctrl-module : phandle of the control module used by PHY driver to power on
>> diff --git a/drivers/phy/phy-ti-pipe3.c b/drivers/phy/phy-ti-pipe3.c
>> index 78bac00..e2f9ad7 100644
>> --- a/drivers/phy/phy-ti-pipe3.c
>> +++ b/drivers/phy/phy-ti-pipe3.c
>> @@ -65,6 +65,9 @@
>>   #define PIPE3_PHY_TX_RX_POWERON		0x3
>>   #define PIPE3_PHY_TX_RX_POWEROFF	0x0
>>   
>> +#define PCIE_PCS_MASK			0xFF0000
>> +#define PCIE_PCS_DELAY_COUNT_SHIFT	0x10
>> +
>>   /*
>>    * This is an Empirical value that works, need to confirm the actual
>>    * value required for the PIPE3PHY_PLL_CONFIGURATION2.PLL_IDLE status
>> @@ -96,9 +99,11 @@ struct ti_pipe3 {
>>   	struct clk		*div_clk;
>>   	struct pipe3_dpll_map	*dpll_map;
>>   	struct regmap		*phy_power_syscon; /* ctrl. reg. acces */
>> +	struct regmap		*pcs_syscon; /* ctrl. reg. acces */
>>   	struct regmap		*dpll_reset_syscon; /* ctrl. reg. acces */
>>   	unsigned int		dpll_reset_reg; /* reg. index within syscon */
>>   	unsigned int		power_reg; /* power reg. index within syscon */
>> +	unsigned int		pcie_pcs_reg; /* pcs reg. index in syscon */
>>   	bool			sata_refclk_enabled;
>>   };
>>   
>> @@ -271,7 +276,16 @@ static int ti_pipe3_init(struct phy *x)
>>   	 * 18-1804.
>>   	 */
>>   	if (of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-pcie")) {
>> -		omap_control_pcie_pcs(phy->control_dev, 0x96);
>> +		if (phy->pcs_syscon) {
>> +			val = 0x96 << OMAP_CTRL_PCIE_PCS_DELAY_COUNT_SHIFT;
>> +			ret = regmap_update_bits(phy->pcs_syscon,
>> +						 phy->pcie_pcs_reg,
>> +						 PCIE_PCS_MASK, val);
>> +			if (ret < 0)
>> +				return ret;
>> +		} else {
>> +			omap_control_pcie_pcs(phy->control_dev, 0x96);
>> +		}
>>   		return 0;
>>   	}
>>   
>> @@ -455,6 +469,22 @@ static int ti_pipe3_probe(struct platform_device *pdev)
>>   			dev_err(&pdev->dev, "unable to get div-clk\n");
>>   			return PTR_ERR(phy->div_clk);
>>   		}
>> +
>> +		phy->pcs_syscon = syscon_regmap_lookup_by_phandle(node,
>> +								  "syscon-pcs");
>> +		if (IS_ERR(phy->pcs_syscon)) {
>> +			dev_dbg(&pdev->dev,
>> +				 "can't get syscon-pcs, using omap control\n");
>> +			phy->pcs_syscon = NULL;
>> +		} else {
>> +			if (of_property_read_u32_index(node,
>> +						       "syscon-pcs", 1,
>> +						       &phy->pcie_pcs_reg)) {
>> +				dev_err(&pdev->dev,
>> +					"couldn't get pcie pcs reg. offset\n");
>> +				return -EINVAL;
>> +			}
>> +		}
>>   	} else {
>>   		phy->div_clk = ERR_PTR(-ENODEV);
>>   	}
>> -- 
>> 1.7.9.5
>>
> 
> Other than that,
> 
> Acked-by: Roger Quadros <rogerq at ti.com>
> 
> cheers,
> -roger
>