[PATCH] irqchip: bcm2835: Add FIQ support

[Noralf Trønnes]

Den 18.06.2015 15:32, skrev Noralf Trønnes:
>
> Den 18.06.2015 04:26, skrev Stephen Warren:
>> On 06/12/2015 11:26 AM, Noralf Trønnes wrote:
>>> Add a duplicate irq range with an offset on the hwirq's so the
>>> driver can detect that enable_fiq() is used.
>>> Tested with downstream dwc_otg USB controller driver.
>> This basically looks OK, but a few comments/thoughts:
>>

>> c) The DT binding needs updating to describe the extra IRQs:
>>
>>> Documentation/devicetree/bindings/interrupt-controller/brcm,bcm28armctrl-ic.txt 
>>>
>
> Ok.
>

I have seconds thoughts on this:
This patch does not change the DT bindings so I don't see what update
I should make. This patch only adds support for the Linux way of
handling FIQ's through enable_fiq(). It doesn't change how interrupts
are described in the DT.