[PATCH 4/9] ARM: STi: DT: Add STiH407 family tsin3 pinctrl configuration

[Peter Griffin]

tsin3 channel can only be configured for serial data transfer.

On B2120 reference design tsin3 is brought out as TSB on the NIMB
slot of the B2004A daughter board.

Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
---
 arch/arm/boot/dts/stih407-pinctrl.dtsi | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm/boot/dts/stih407-pinctrl.dtsi b/arch/arm/boot/dts/stih407-pinctrl.dtsi
index 6b11568..13b469c 100644
--- a/arch/arm/boot/dts/stih407-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stih407-pinctrl.dtsi
@@ -522,6 +522,18 @@
 					};
 				};
 			};
+
+			tsin3 {
+				pinctrl_tsin3_serial: tsin3_serial {
+					st,pins {
+						DATA7 = <&pio14 1 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+						CLKIN = <&pio14 0 ALT1 IN CLKNOTDATA 0 CLK_A>;
+						VALID = <&pio13 6 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+						ERROR = <&pio13 5 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+						PKCLK = <&pio13 7 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+					};
+				};
+			};
 		};
 
 		pin-controller-front1 {
-- 
1.9.1