[PATCH 5/9] ARM: STi: DT: Add STiH407 family tsin4 pinctrl configuration
Peter Griffin
peter.griffin at linaro.org
Wed Jun 10 07:04:02 PDT 2015
tsin4 can only be configured for serial data transfer. However
depending on board design, two alternate pin configurations
are available. One in pin-controller-front0 and the other in
pin-controller-front1.
pinctrl_tsin4_serial_alt3 is brought out on B2120 reference
design as TSC on NIMA slot of the B2004A daughter board.
Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
---
arch/arm/boot/dts/stih407-pinctrl.dtsi | 24 ++++++++++++++++++++++++
1 file changed, 24 insertions(+)
diff --git a/arch/arm/boot/dts/stih407-pinctrl.dtsi b/arch/arm/boot/dts/stih407-pinctrl.dtsi
index 13b469c..702f42d 100644
--- a/arch/arm/boot/dts/stih407-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stih407-pinctrl.dtsi
@@ -534,6 +534,18 @@
};
};
};
+
+ tsin4 {
+ pinctrl_tsin4_serial_alt3: tsin4_serial_alt3 {
+ st,pins {
+ DATA7 = <&pio14 6 ALT3 IN SE_NICLK_IO 0 CLK_A>;
+ CLKIN = <&pio14 5 ALT3 IN CLKNOTDATA 0 CLK_A>;
+ VALID = <&pio14 3 ALT3 IN SE_NICLK_IO 0 CLK_B>;
+ ERROR = <&pio14 2 ALT3 IN SE_NICLK_IO 0 CLK_B>;
+ PKCLK = <&pio14 4 ALT3 IN SE_NICLK_IO 0 CLK_A>;
+ };
+ };
+ };
};
pin-controller-front1 {
@@ -547,6 +559,18 @@
interrupts-names = "irqmux";
ranges = <0 0x09210000 0x10000>;
+ tsin4 {
+ pinctrl_tsin4_serial_alt1: tsin4_serial_alt1 {
+ st,pins {
+ DATA7 = <&pio20 4 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+ CLKIN = <&pio20 3 ALT1 IN CLKNOTDATA 0 CLK_A>;
+ VALID = <&pio20 1 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+ ERROR = <&pio20 0 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+ PKCLK = <&pio20 2 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+ };
+ };
+ };
+
pio20: pio at 09210000 {
gpio-controller;
#gpio-cells = <1>;
--
1.9.1
More information about the linux-arm-kernel
mailing list