[PATCH] ARM: dts: sun7i: Change cubietruck wifi enable pin to use mmc-pwrseq

Hans de Goede hdegoede at redhat.com
Fri Jul 31 08:41:52 PDT 2015


The wifi-enable pin of the ap6210 module is not really a regulator,
switch to the mmc-pwrseq framework for controlling it. This more
accurately reflects how the hardware actually works.

Signed-off-by: Hans de Goede <hdegoede at redhat.com>
---
 arch/arm/boot/dts/sun7i-a20-cubietruck.dts | 13 +++++--------
 1 file changed, 5 insertions(+), 8 deletions(-)

diff --git a/arch/arm/boot/dts/sun7i-a20-cubietruck.dts b/arch/arm/boot/dts/sun7i-a20-cubietruck.dts
index de3e195..0b2f914 100644
--- a/arch/arm/boot/dts/sun7i-a20-cubietruck.dts
+++ b/arch/arm/boot/dts/sun7i-a20-cubietruck.dts
@@ -88,15 +88,11 @@
 		};
 	};
 
-	reg_vmmc3: vmmc3 {
-		compatible = "regulator-fixed";
+	mmc3_pwrseq: mmc3_pwrseq {
+		compatible = "mmc-pwrseq-simple";
 		pinctrl-names = "default";
 		pinctrl-0 = <&vmmc3_pin_cubietruck>;
-		regulator-name = "vmmc3";
-		regulator-min-microvolt = <3300000>;
-		regulator-max-microvolt = <3300000>;
-		enable-active-high;
-		gpio = <&pio 7 9 GPIO_ACTIVE_HIGH>;
+		reset-gpios = <&pio 7 9 GPIO_ACTIVE_LOW>; /* PH9 WIFI_EN */
 	};
 };
 
@@ -179,7 +175,8 @@
 &mmc3 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc3_pins_a>;
-	vmmc-supply = <&reg_vmmc3>;
+	vmmc-supply = <&reg_vcc3v3>;
+	mmc-pwrseq = <&mmc3_pwrseq>;
 	bus-width = <4>;
 	non-removable;
 	status = "okay";
-- 
2.4.3




More information about the linux-arm-kernel mailing list