[PATCH] arm64: pci: add support for pci_mmap_page_range

[Jerin Jacob]

On Tue, Jul 28, 2015 at 12:20:57PM +0100, Will Deacon wrote:
> On Mon, Jul 27, 2015 at 06:10:29AM +0100, Jerin Jacob wrote:
> > On Fri, Jul 24, 2015 at 03:41:03PM +0100, Will Deacon wrote:
> > > On Fri, Jul 24, 2015 at 06:54:23AM +0100, Jerin Jacob wrote:
> > > > +int pci_mmap_page_range(struct pci_dev *dev, struct vm_area_struct *vma,
> > > > +		enum pci_mmap_state mmap_state, int write_combine)
> > > > +{
> > > > +	/*
> > > > +	* I/O space can be accessed via normal processor loads and stores on
> > > > +	* this platform but for now we elect not to do this and portable
> > > > +	* drivers should not do this anyway.
> > > > +	*/
> > > > +	if (mmap_state == pci_mmap_io)
> > > > +		return -EINVAL;
> > > > +
> > > > +	if (write_combine)
> > > > +		vma->vm_page_prot = pgprot_writecombine(vma->vm_page_prot);
> > > > +	else
> > > > +		vma->vm_page_prot = pgprot_noncached(vma->vm_page_prot);
> > > > +
> > > > +	return remap_pfn_range(vma, vma->vm_start, vma->vm_pgoff,
> > > > +	       vma->vm_end - vma->vm_start, vma->vm_page_prot);
> > > > +}
> > > 
> > > So pci_iomap_range chooses the memory attributes based on the BAR flags
> > > (and even then it looks weird -- CACHEABLE => ioremap, else ioremap_nocache,
> > > which is just the same as ioremap on arm64).
> > > 
> > > It would be good to understand (a) why this is different and (b) what
> > 
> > AFAIU, pci_iomap_range is the generic implementation and chooses to
> > use only minimal attributes that works on all the architectures.
> > The primary consumer of pci_iomap_range is virtio_pci driver,Which
> > doesn't care about HW PCI memory attributes like Prefetchable.
> 
> pci_iomap calls pci_iomap_range.

Yes, I missed that.

> 
> > > the consistent set of attributes should be.
> > 
> > PCI perspective, memory attributes are Prefetchable and non-Prefetchable
> > for a given BAR.
> > 
> > Former one does have read side-effects or supports write
> > merging(typically used
> > by graphics memory) and latter one has read side effects and does not
> > support write merging(typically used by register files)
> > 
> > IMO, In armv8 nomenclature, MT_NORMAL_NC and MT_DEVICE_nGnRnE map
> > correctly to above PCI memory attribute definitions.
> 
> I agree with your choice of memory types (well, almost. We probably don't
> need the nE), I'm just after some consistency within the kernel, because

I thought so, However, Since PCIe deals with off-chip peripherals,
IMO it should be MT_DEVICE_nGnRnE(strongly ordered).
Early write acknowledgment may have side effect based on the topology.
(connected under Bridge etc).
IMO, It make sense to mark as nGnRE for on-chip peripherals. But
If you still think we need to mark as nGnRE then I can submit v2 with
nGnRE else IMO, currect patch is fine for pci_mmap_page_range

Jerin

> pci_iomap_range looks wrong to me. Another different example is
> pci_ioremap_bar, which always uses ioremap_nocache.
> 
> Will