[linux-sunxi] [RFC] ARM: dts: sunxi: Add regulators and board-specific operating points for LeMaker BananaPi

[Maxime Ripard]

On Tue, Jul 28, 2015 at 11:02:16AM +0200, Timo Sigurdsson wrote:
> Hi,
> 
> Chen-Yu Tsai schrieb am 27.07.2015 15:14:
> >> ChenYu (in the CC), since you did most of the original work here, do
> >> you know why we have an op at 0.9 volt, but none of our boards allow the
> >> voltage to go that low in the regulator settings ?
> > 
> > I'm on vacation now, so apologies for the bad formatting.
> > 
> > The OPPs are from a common subset
> > of the settings from the fex files available
> > at the time. Some fex files actually set
> > min and max voltage thus eliminating
> > the highest and lowest OPPs.
> > 
> > At least that is how Maxime and I
> > interpreted them.
> 
> IMHO for a common maximum opp that's a good approach. But for the lowest
> frequency setting, it would seem more logical to me, to raise the voltage
> to a point where all boards will run fine with them, unless those boards 
> cannot handle the frequency regardless of the higher voltage.

Agreed.

Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 819 bytes
Desc: Digital signature
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20150728/5a5e33c7/attachment-0001.sig>