[RFCv2 2/3] dts: zynq: Add devicetree entry for Xilinx Zynq reset controller.

Moritz Fischer moritz.fischer at ettus.com
Mon Jul 27 22:03:49 PDT 2015

Hi Michal,

I agree we need to be careful with changing the bindings.

On Sun, Jul 26, 2015 at 11:56 PM, Michal Simek <monstr at monstr.eu> wrote:
> Hi Moritz,
> On 07/25/2015 02:21 AM, Moritz Fischer wrote:
>> Signed-off-by: Moritz Fischer <moritz.fischer at ettus.com>
>> ---
>>  arch/arm/boot/dts/zynq-7000.dtsi            | 43 ++++++++++++-
> This patch is nice in general but every change in binding should be
> discussed separately. There is also necessary to wire them up in the
> driver to do action. That's why I think that will be the best just to
> add the code to slcr and keep others untouched.

Ok, just to clarify: You'd suggest to just add the rstc as child node
to the slcr,
and leave the other nodes untouched?

> For example MACB/GEM is one example. Adding names to this node and
> extending driver to work properly with reset means that all others MACB
> users will be affected. Definitely this patch should be ACKed by Nicolas.
> Thanks,
> Michal
> --
> Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
> w: www.monstr.eu p: +42-0-721842854
> Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/
> Maintainer of Linux kernel - Xilinx Zynq ARM architecture
> Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform


More information about the linux-arm-kernel mailing list