[linux-sunxi] [RFC] ARM: dts: sunxi: Add regulators and board-specific operating points for LeMaker BananaPi

[public_timo.s at silentcreek.de]

Hi again,

one more thing...

Hans de Goede schrieb am 27.07.2015 10:07:
> IMHO we should just stick with the standard operating points unless we know
> that there are stability issues with them (such as e.g. on the A10 OlinuxIno
> Lime).

If we stick to the standard operating points, shouldn't we honor their voltages
as well? If we set the minimum voltage for dcdc2 to 1.0V (as you did) or 1.05V
(as I did), this means that the lowest operating point of 144MHz at 0.9V defined
in sun7i-a20.dtsi (and with my definition the 312MHz opp as well) will not be
available because cpufreq-dt simply ignores operating points that aren't within
the set voltage range for that regulator.


Regards,

Timo