[RESEND PATCH v2 1/2] dt: snps, dw-apb-ssi: Document new I/O data register width property

[Michael van der Westhuizen]

This change documents a new property for the snps,dw-apb-ssi device,
allowing an implementer to specify either four byte or two bytes
access to the SPI controller data register.

This supports a change that unbreaks this driver on picoXcell
platforms.

Signed-off-by: Michael van der Westhuizen <michael at smart-africa.com>
---

Changes in v2:
  - Incorporate review feedback from Andy Shevchenko, reworking the
    bindings to reflect common practice.

 Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt b/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt
index bd99193..b4f1086 100644
--- a/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt
+++ b/Documentation/devicetree/bindings/spi/snps,dw-apb-ssi.txt
@@ -10,6 +10,8 @@ Required properties:
 Optional properties:
 - cs-gpios : Specifies the gpio pis to be used for chipselects.
 - num-cs : The number of chipselects. If omitted, this will default to 4.
+- snps,reg-io-width : The I/O register width (in bytes) implemented by
+  this device.  Supported values are 2 or 4 (the default).
 
 Child nodes as per the generic SPI binding.
 
-- 
2.1.4