[PATCH 1/4] mfd: 88pm800: Update the header file with 32K clk related macros

[Lee Jones]

On Tue, 21 Jul 2015, Vaibhav Hiremath wrote:

> Update header file with required macros for 32KHz buffered clock
> output of 88PM800 family of device.
> These macros will be used in clk provider driver.
> 
> Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath at linaro.org>
> ---
>  include/linux/mfd/88pm80x.h | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/include/linux/mfd/88pm80x.h b/include/linux/mfd/88pm80x.h
> index 05d9bad..680e4eb 100644
> --- a/include/linux/mfd/88pm80x.h
> +++ b/include/linux/mfd/88pm80x.h
> @@ -91,6 +91,7 @@ enum {
>  /* Referance and low power registers */
>  #define PM800_LOW_POWER1		(0x20)
>  #define PM800_LOW_POWER2		(0x21)
> +#define PM800_LOW_POWER2_XO_LJ_EN	BIT(5)
>  
>  #define PM800_LOW_POWER_CONFIG3		(0x22)
>  #define PM800_LDOBK_FREEZE		BIT(7)
> @@ -138,6 +139,13 @@ enum {
>  #define PM800_ALARM			BIT(5)
>  #define PM800_RTC1_USE_XO		BIT(7)
>  
> +#define PM800_32K_OUTX_SEL_MASK		(0x3)
> +/* 32KHz clk output sel mode */
> +#define PM800_32K_OUTX_SEL_ZERO		(0x0)
> +#define PM800_32K_OUTX_SEL_INT_32KHZ	(0x1)
> +#define PM800_32K_OUTX_SEL_XO_32KHZ	(0x2)
> +#define PM800_32K_OUTX_SEL_HIZ		(0x3)

Why do these need to be in brackets?

>  /* Regulator Control Registers: BUCK1,BUCK5,LDO1 have DVC */
>  
>  /* buck registers */
> @@ -208,6 +216,10 @@ enum {
>  #define PM800_PMOD_MEAS1		0x52
>  #define PM800_PMOD_MEAS2		0x53
>  
> +/* Oscillator control */
> +#define PM800_OSC_CNTRL1		(0x50)
> +#define PM800_OSC_CNTRL1_OSC_FREERUN_EN	BIT(1)
> +
>  #define PM800_GPADC0_MEAS1		0x54
>  #define PM800_GPADC0_MEAS2		0x55
>  #define PM800_GPADC1_MEAS1		0x56

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog