[PATCH v3 1/4] PCI: iproc: enable arm64 support for iProc PCIe

Ray Jui rjui at broadcom.com
Tue Jul 21 13:50:28 PDT 2015



On 7/21/2015 1:30 PM, Bjorn Helgaas wrote:
> On Wed, Jul 15, 2015 at 09:39:20PM -0700, Ray Jui wrote:
>> This patch enables arm64 support to the iProc PCIe driver
> 
> This needs a little more explanation: ARM has a common struct pci_sys_data
> but ARM64 does not,

Correct, and according to Arnd, there's already work in process of
removing the need for pci_sys_data on arm32. Before that is done, we
need this in the driver for it to work on both arm32 and arm64.

and ARM needs pci_fixup_irqs() but ARM64 does not (why
> not?),

under arch/arm64/kernel/pci.c:

 41 /*
 42  * Try to assign the IRQ number from DT when adding a new device
 43  */
 44 int pcibios_add_device(struct pci_dev *dev)
 45 {
 46         dev->irq = of_irq_parse_and_map_pci(dev, 0, 0);
 47
 48         return 0;
 49 }

interrupt is automatically parsed and mapped when adding a new device
for arm64.

ARM uses the common pci_sys_data for the PCI sysdata while ARM64
> uses a driver-specific sysdata, etc.
> 

Correct. pci_sys_data for arm32 will eventually be removed, so all arm32
based PCie host should only need to carry driver specific sysdata.

>> Signed-off-by: Ray Jui <rjui at broadcom.com>
>> Reviewed-by: Scott Branden <sbranden at broadcom.com>
>> ---
>>  drivers/pci/host/pcie-iproc.c |   15 ++++-----------
>>  drivers/pci/host/pcie-iproc.h |    8 ++++++--
>>  2 files changed, 10 insertions(+), 13 deletions(-)
>>
>> diff --git a/drivers/pci/host/pcie-iproc.c b/drivers/pci/host/pcie-iproc.c
>> index d77481e..8a556d5 100644
>> --- a/drivers/pci/host/pcie-iproc.c
>> +++ b/drivers/pci/host/pcie-iproc.c
>> @@ -58,11 +58,6 @@
>>  #define SYS_RC_INTX_EN               0x330
>>  #define SYS_RC_INTX_MASK             0xf
>>  
>> -static inline struct iproc_pcie *sys_to_pcie(struct pci_sys_data *sys)
>> -{
>> -	return sys->private_data;
>> -}
>> -
>>  /**
>>   * Note access to the configuration registers are protected at the higher layer
>>   * by 'pci_lock' in drivers/pci/access.c
>> @@ -71,8 +66,7 @@ static void __iomem *iproc_pcie_map_cfg_bus(struct pci_bus *bus,
>>  					    unsigned int devfn,
>>  					    int where)
>>  {
>> -	struct pci_sys_data *sys = bus->sysdata;
>> -	struct iproc_pcie *pcie = sys_to_pcie(sys);
>> +	struct iproc_pcie *pcie = bus->sysdata;
>>  	unsigned slot = PCI_SLOT(devfn);
>>  	unsigned fn = PCI_FUNC(devfn);
>>  	unsigned busno = bus->number;
>> @@ -208,10 +202,7 @@ int iproc_pcie_setup(struct iproc_pcie *pcie, struct list_head *res)
>>  
>>  	iproc_pcie_reset(pcie);
>>  
>> -	pcie->sysdata.private_data = pcie;
>> -
>> -	bus = pci_create_root_bus(pcie->dev, 0, &iproc_pcie_ops,
>> -				  &pcie->sysdata, res);
>> +	bus = pci_create_root_bus(pcie->dev, 0, &iproc_pcie_ops, pcie, res);
>>  	if (!bus) {
>>  		dev_err(pcie->dev, "unable to create PCI root bus\n");
>>  		ret = -ENOMEM;
>> @@ -229,7 +220,9 @@ int iproc_pcie_setup(struct iproc_pcie *pcie, struct list_head *res)
>>  
>>  	pci_scan_child_bus(bus);
>>  	pci_assign_unassigned_bus_resources(bus);
>> +#ifdef CONFIG_ARM
>>  	pci_fixup_irqs(pci_common_swizzle, pcie->map_irq);
>> +#endif
>>  	pci_bus_add_devices(bus);
>>  
>>  	return 0;
>> diff --git a/drivers/pci/host/pcie-iproc.h b/drivers/pci/host/pcie-iproc.h
>> index ba0a108..0ee9673 100644
>> --- a/drivers/pci/host/pcie-iproc.h
>> +++ b/drivers/pci/host/pcie-iproc.h
>> @@ -18,18 +18,22 @@
>>  
>>  /**
>>   * iProc PCIe device
>> + * @sysdata: Per PCI controller data. This needs to be kept at the beginning of
>> + * struct iproc_pcie, to enable support of both ARM32 and ARM64 platforms with
>> + * minimal changes in the iProc PCIe core driver
>>   * @dev: pointer to device data structure
>>   * @base: PCIe host controller I/O register base
>>   * @resources: linked list of all PCI resources
>> - * @sysdata: Per PCI controller data
>>   * @root_bus: pointer to root bus
>>   * @phy: optional PHY device that controls the Serdes
>>   * @irqs: interrupt IDs
>>   */
>>  struct iproc_pcie {
>> +#ifdef CONFIG_ARM
>> +	struct pci_sys_data sysdata;
>> +#endif
> 
> I'm OK with adding #ifdefs to make this work on both ARM and ARM64.  We can
> at least see the ifdefs and know what needs to be fixed.  I'm a little more
> hesitant about adding code that depends on the position of sysdata within
> struct iproc_pcie.  I'd rather have something ugly and robust that cries
> out for fixing than something minimal and fragile.
> 

Yes that was my original code and that was a bit ugly. Arnd proposed
this and it does indeed make the look a lot cleaner. But yeah, it now
depends on the location of struct pci_sys_data in memory and I see your
concern. In fact, I asked exactly the same question to Arnd.

Are you okay with living with this for a little while until struct
pci_sys_data is eventually removed from arm32?

> I see that your v1 patch added #ifdef CONFIG_ARM around sysdata at its
> original location below, and you mentioned that you took Arnd's advice to
> move sysdata to the beginning of the structure, but I don't see Arnd's
> email on the list.
> 

Sorry maybe you need to elaborate here. Am I supposed to add Arnd's name
in the commit message? Other than that, Arnd is on this email thread.

>>  	struct device *dev;
>>  	void __iomem *base;
>> -	struct pci_sys_data sysdata;
>>  	struct pci_bus *root_bus;
>>  	struct phy *phy;
>>  	int irqs[IPROC_PCIE_MAX_NUM_IRQS];
>> -- 
>> 1.7.9.5
>>



More information about the linux-arm-kernel mailing list