[PATCH-v2 2/2] regulator: 88pm800: Add support for configuration of dual phase on BUCK1

[Vaibhav Hiremath]

88PM860 device supports dual phase mode on BUCK1 output.
In normal usecase, BUCK1A and BUCK1B operates independently with 3A
capacity. And they both can work as a dual phase providing 6A capacity.

This patch updates the regulator driver to read the respective
DT property and enable dual-phase mode on BUCK1.

Note that, this is init time (one time) initialization.

Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath at linaro.org>
---
 drivers/regulator/88pm800.c | 31 +++++++++++++++++++++++++++++++
 include/linux/mfd/88pm80x.h |  3 +++
 2 files changed, 34 insertions(+)

diff --git a/drivers/regulator/88pm800.c b/drivers/regulator/88pm800.c
index e846e4c..1bf2b35 100644
--- a/drivers/regulator/88pm800.c
+++ b/drivers/regulator/88pm800.c
@@ -267,6 +267,31 @@ static struct pm800_regulator_info pm860_regulator_info[] = {
 	PM800_LDO(ldo20, LDO20, LDO_ENA1_3, 3, 10000, ldo_volt_table2),
 };
 
+static int pm800_regulator_init(struct platform_device *pdev)
+{
+	struct pm800_regulators *pm800_data = platform_get_drvdata(pdev);
+	struct pm80x_chip *chip = pm800_data->chip;
+	int ret;
+
+	/* Currently only supported on 88pm860 device */
+	if (chip->type != CHIP_PM860)
+		return 0;
+
+	if (of_property_read_bool(pdev->dev.of_node,
+				"marvell,88pm860-buck1-dualphase-en")) {
+		ret = regmap_update_bits(chip->subchip->regmap_power,
+					PM860_BUCK1_MISC,
+					BUCK1_DUAL_PHASE_SEL,
+					BUCK1_DUAL_PHASE_SEL);
+		if (ret) {
+			dev_err(chip->dev, "failed to set dual-pase mode %d\n", ret);
+			return ret;
+		}
+	}
+
+	return 0;
+}
+
 static int pm800_regulator_probe(struct platform_device *pdev)
 {
 	struct pm80x_chip *chip = dev_get_drvdata(pdev->dev.parent);
@@ -336,6 +361,12 @@ static int pm800_regulator_probe(struct platform_device *pdev)
 		}
 	}
 
+	ret = pm800_regulator_init(pdev);
+	if (ret) {
+		dev_err(&pdev->dev, "failed to init 88pm800 regulator device\n");
+		return ret;
+	}
+
 	return 0;
 }
 
diff --git a/include/linux/mfd/88pm80x.h b/include/linux/mfd/88pm80x.h
index a92d173..05d9bad 100644
--- a/include/linux/mfd/88pm80x.h
+++ b/include/linux/mfd/88pm80x.h
@@ -295,6 +295,9 @@ enum {
 #define PM860_BUCK4_MISC2		(0x82)
 #define PM860_BUCK4_FULL_DRV		BIT(2)
 
+#define PM860_BUCK1_MISC		(0x8E)
+#define BUCK1_DUAL_PHASE_SEL		BIT(2)
+
 struct pm80x_rtc_pdata {
 	int		vrtc;
 	int		rtc_wakeup;
-- 
1.9.1