[PATCH] PCI: xilinx: Add check for MSI interrupt flag before handling as INTx

[Bjorn Helgaas]

On Tue, Jul 07, 2015 at 05:54:19PM +0100, Russell Joyce wrote:
> Occasionally both MSI and INTx bits in the interrupt decode register are
> set at once by the Xilinx AXI PCIe Bridge, so the MSI flag in the
> interrupt message should be checked to ensure that the correct handler is
> used.
> 
> If this check is not in place and the interrupt message type is MSI, the
> INTx handler will be used erroneously when both type bits are set.
> This will also be followed by a second read of the message FIFO, which can
> result in the function returning early and the interrupt decode register
> not being cleared if the FIFO is now empty.
> 
> Signed-off-by: Russell Joyce <russell.joyce at york.ac.uk>
> ---
>  drivers/pci/host/pcie-xilinx.c | 19 +++++++++++--------
>  1 file changed, 11 insertions(+), 8 deletions(-)
> 
> diff --git a/drivers/pci/host/pcie-xilinx.c b/drivers/pci/host/pcie-xilinx.c
> index f1a06a0..dcb9b57 100644
> --- a/drivers/pci/host/pcie-xilinx.c
> +++ b/drivers/pci/host/pcie-xilinx.c
> @@ -449,14 +449,17 @@ static irqreturn_t xilinx_pcie_intr_handler(int irq, void *data)
>  			return IRQ_HANDLED;
>  		}
>  
> -		/* Clear interrupt FIFO register 1 */
> -		pcie_write(port, XILINX_PCIE_RPIFR1_ALL_MASK,
> -			   XILINX_PCIE_REG_RPIFR1);
> -
> -		/* Handle INTx Interrupt */
> -		val = ((val & XILINX_PCIE_RPIFR1_INTR_MASK) >>
> -			XILINX_PCIE_RPIFR1_INTR_SHIFT) + 1;
> -		generic_handle_irq(irq_find_mapping(port->irq_domain, val));
> +		if (!(val & XILINX_PCIE_RPIFR1_MSI_INTR)) {
> +			/* Clear interrupt FIFO register 1 */
> +			pcie_write(port, XILINX_PCIE_RPIFR1_ALL_MASK,
> +				   XILINX_PCIE_REG_RPIFR1);
> +
> +			/* Handle INTx Interrupt */
> +			val = ((val & XILINX_PCIE_RPIFR1_INTR_MASK) >>
> +				XILINX_PCIE_RPIFR1_INTR_SHIFT) + 1;
> +			generic_handle_irq(irq_find_mapping(port->irq_domain,
> +							    val));

Xilinx folks, any comments?

Russell, is there a good way to reproduce this so others can verify the
problem and the fix?

> +		}
>  	}
>  
>  	if (status & XILINX_PCIE_INTR_MSI) {
> -- 
> 2.1.4
>