[PATCH 4/4] arm64: dts: Add Broadcom North Star 2 support

[Mark Rutland]

Hi,

> +/dts-v1/;
> +
> +#include "ns2.dtsi"
> +
> +/ {
> +       model = "Broadcom NS2 SVK";
> +       compatible = "brcm,ns2-svk", "brcm,ns2";
> +
> +       chosen {
> +               bootargs = "console=ttyS0,115200n8 earlycon=uart8250,mmio32,0x66130000";
> +       };

Please use stdout-path instead (you can use /aliases to make it
simpler). It'll save a redundant description of the UART and will remove
the dependency on Linux-specific naming of the UART.

[...]

> +/ {
> +       compatible = "brcm,ns2";
> +       interrupt-parent = <&gic>;
> +       #address-cells = <2>;
> +       #size-cells = <2>;
> +
> +       cpus {
> +               #address-cells = <2>;
> +               #size-cells = <0>;
> +
> +               cpu at 0 {
> +                       device_type = "cpu";
> +                       compatible = "arm,cortex-a57", "arm,armv8";
> +                       reg = <0 0>;
> +                       enable-method = "spin-table";
> +                       cpu-release-addr = <0 0x84b00000>;
> +               };
> +       };

Shouldn't the other CPUs be described?

Using spin-table for SMP is somewhat unfortunate, as it comes with a
number of problems (e.g. unwoken secondaries spinning in the kernel). I
would strongly advise using PSCI instead.

> +
> +       timer {
> +               compatible = "arm,armv8-timer";
> +               interrupts = <GIC_PPI 13 (GIC_CPU_MASK_RAW(0xff) |
> +                             IRQ_TYPE_EDGE_RISING)>,
> +                            <GIC_PPI 14 (GIC_CPU_MASK_RAW(0xff) |
> +                             IRQ_TYPE_EDGE_RISING)>,
> +                            <GIC_PPI 11 (GIC_CPU_MASK_RAW(0xff) |
> +                             IRQ_TYPE_EDGE_RISING)>,
> +                            <GIC_PPI 10 (GIC_CPU_MASK_RAW(0xff) |
> +                             IRQ_TYPE_EDGE_RISING)>;
> +               clock-frequency = <25000000>;
> +       };

Please fix your firmware to configure CNTFRQ_EL0, it is simply a bug not
to, and using clock-frequency does not fix all the problems that not
configuring it causes.

Thanks,
Mark.