[PATCH] dts: ls1021a: Add dts nodes for eTSEC0, eTSEC1 and eTSEC2

[Manoil Claudiu]

> -----Original Message-----
> From: Shawn Guo [mailto:shawnguo at kernel.org]
> Sent: Sunday, July 12, 2015 9:51 AM
> To: Wang Huan-B18965
> Cc: devicetree at vger.kernel.org; linux-arm-kernel at lists.infradead.org; linux-
> kernel at vger.kernel.org; shawn.guo at linaro.org; Manoil Claudiu-B08782;
> Wang Huan-B18965
> Subject: Re: [PATCH] dts: ls1021a: Add dts nodes for eTSEC0, eTSEC1 and
> eTSEC2
> 
> On Thu, Jun 25, 2015 at 02:24:58PM +0800, Alison Wang wrote:
> > @@ -391,6 +394,85 @@
> >  			reg = <0x0 0x2d24000 0x0 0x4000>;
> >  		};
> >
> > +		enet0: ethernet at 2d10000 {
> 
> Most of the vendor specific properties below are undocumented bindings.
> 
> Shawn
> 

Hi Shawn,

Please note that these properties (with only one exception) were accepted long time ago
and are in use for the upstream powerpc platforms, eg:
$ git grep fsl,num_rx_queues
arch/powerpc/boot/dts/fsl/pq3-etsec2-0.dtsi:    fsl,num_rx_queues = <0x8>;
arch/powerpc/boot/dts/fsl/pq3-etsec2-1.dtsi:    fsl,num_rx_queues = <0x8>;
arch/powerpc/boot/dts/fsl/pq3-etsec2-2.dtsi:    fsl,num_rx_queues = <0x8>;
drivers/net/ethernet/freescale/gianfar.c:                       ret = of_property_read_u32(np, "fsl,num_rx_queues",

So, I think the bindings documentation could be added in a separate, follow-up, patch.

Thanks,
Claudiu