[PATCH 5/6] mfd: devicetree: bindings: 88pm800: Add DT property for dual phase enable

[Krzysztof Kozlowski]

W dniu 09.07.2015 o 20:47, Vaibhav Hiremath pisze:
> 88PM860 family of device supports dual phase mode on BUCK1 supply
> providing total 6A capacity.
> Note that by default they operate independently with 3A capacity.
> 
> This patch adds the devicetree binding to enable this
> feature.
> 
> Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath at linaro.org>
> ---
>  Documentation/devicetree/bindings/mfd/88pm800.txt | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/mfd/88pm800.txt b/Documentation/devicetree/bindings/mfd/88pm800.txt
> index ae1311c..c756b31 100644
> --- a/Documentation/devicetree/bindings/mfd/88pm800.txt
> +++ b/Documentation/devicetree/bindings/mfd/88pm800.txt
> @@ -15,6 +15,12 @@ Optional properties :
>        CLK32K3 - for 88pm800
>        CLK32K2 - for 88pm860
>  
> +   (Applicable only to PXA910 family):
> +
> + - marvell,88pm860-buck1-dualphase-en	: If set, enable dual phase on BUCK1,
> +   providing 6A capacity.
> +   Without this both BUCK1A and BUCK1B operates independently with 3A capacity.
> +

1. How does this relates to regulator driver? The
drivers/regulator/88pm800.c defines constraints for regulator which may
be contradictory.

2. This looks like a job for regulator driver, not MFD. Then you could
use standard regulator bindings (setting maximum current to 6A would
change the regulator to different mode).

Best regards,
Krzysztof