[PATCH v3 3/3] dt-binding:Documents the mbigen bindings

[Mark Rutland]

On Mon, Jul 06, 2015 at 08:09:08AM +0100, Ma Jun wrote:
> Add the mbigen msi interrupt controller bindings document
> 
> Change in v3:
> ---Change the compatible string
> ---Change the interrupt cells definition.
> 
> Signed-off-by: Ma Jun <majun258 at huawei.com>
> ---
>  Documentation/devicetree/bindings/arm/mbigen.txt |   65 ++++++++++++++++++++++
>  1 files changed, 65 insertions(+), 0 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/arm/mbigen.txt
> 
> diff --git a/Documentation/devicetree/bindings/arm/mbigen.txt b/Documentation/devicetree/bindings/arm/mbigen.txt
> new file mode 100644
> index 0000000..cf92ef8
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/arm/mbigen.txt
> @@ -0,0 +1,65 @@
> +Hisilicon mbigen device tree bindings.
> +=======================================
> +
> +Mbigen means: message based interrupt generator.
> +
> +MBI is kind of msi interrupt only used on Non-PCI devices.
> +
> +To reduce the wired interrupt number connected to GIC,
> +Hisilicon designed mbigen to collect and generate interrupt.
> +
> +
> +Non-pci devices can connect to mbigen and gnerate the inteerrupt
> +by wirtting ITS register.

Please run this through a spell checker to get rid of typos.

> +
> +The mbigen and devices connect to mbigen have the following properties:
> +
> +
> +Mbigen required properties:
> +-------------------------------------------
> +-compatible: Should be "hisilicon,mbigen-v2"
> +-msi-parent: should specified the ITS mbigen connected
> +-interrupt controller: Identifies the node as an interrupt controller
> +- #interrupt-cells : Specifies the number of cells needed to encode an
> +  interrupt source. The value is 5 now.
> +
> +  The 1st cell is the device id.

Does a given mbigen block generate interrupts with different ITS device
IDs? Or does a given mbigen block have a single device ID shared by all
interrupts it generates?

> +  The 2nd cell is the totall interrupt number of this device?

I don't follow. What is a "total interrupt number"?

> +  The 3rd cell is the hardware pin number of the interrupt.
> +  This value depends on the Soc design.

This property seems sane.

> +  The 4th cell is the mbigen node number. This value should refer to the
> +  vendor soc specification.

What is this, and why do you think you need it?

Surely the address of the mbigen node is a sufficient unique identifier?

> +  The 5th cell is the interrupt trigger type, encoded as follows:
> +		1 = edge triggered
> +		4 = level triggered

Hmm. How are level-triggered interrupts expected to be handled by the
mbigen?

> +
> +- reg: Specifies the base physical address and size of the ITS
> +  registers.

NAK. You should not describe ITS properties here given this is not the
ITS.

Perhaps you mean "the mbigen registers"?

Thanks,
Mark.