[PATCH 3/4] ARM: dts: Include exynos5420-pinctrl after the nodes were defined

[Javier Martinez Canillas]

The dtc compiler combines all the defined nodes that have the same path
so a device node definition can be in one file and later be extended in
another one.

That's the case of the Exynos5420 pinctrl device nodes that are defined
in the exynos5420.dtsi file and extended in exynos5420-pinctrl.dtsi.

But since the exynos5420.dtsi file includes the exynos5420-pinctrl.dtsi
before the pinctrl device nodes are actually defined, the definition of
the pinctrl device nodes happens in exynos5420-pinctrl.dtsi and are
extended in exynos5420.dtsi.

That is the opposite of the original intention so even when there is no
difference in practice, the exynos5420-pinctrl.dtsi include should be
moved at the end of the exynos5420.dtsi file after the pinctrl device
nodes have been already defined.

This will also allow to later change the exynos5420-pinctrl.dtsi file
to use labels instead of full paths to extend the pinctrl nodes. Since
keeping the include at the top, would cause a dtc build error due the
pinctrl labels not being defined yet.

Signed-off-by: Javier Martinez Canillas <javier at osg.samsung.com>
---

 arch/arm/boot/dts/exynos5420.dtsi | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/exynos5420.dtsi b/arch/arm/boot/dts/exynos5420.dtsi
index 534f27ceb10b..df9aee92ecf4 100644
--- a/arch/arm/boot/dts/exynos5420.dtsi
+++ b/arch/arm/boot/dts/exynos5420.dtsi
@@ -15,7 +15,6 @@
 
 #include <dt-bindings/clock/exynos5420.h>
 #include "exynos5.dtsi"
-#include "exynos5420-pinctrl.dtsi"
 
 #include <dt-bindings/clock/exynos-audss-clk.h>
 
@@ -1166,3 +1165,5 @@
 	clocks = <&clock CLK_UART3>, <&clock CLK_SCLK_UART3>;
 	clock-names = "uart", "clk_uart_baud0";
 };
+
+#include "exynos5420-pinctrl.dtsi"
-- 
2.4.3