[PATCH v4 2/2] ACPI / ARM64 : use the new BAD_MADT_GICC_ENTRY macro

[Al Stone]

For those parts of the arm64 ACPI code that need to check GICC subtables
in the MADT, use the new BAD_MADT_GICC_ENTRY macro instead of the previous
BAD_MADT_ENTRY.  The new macro takes into account differences in the size
of the GICC subtable that the old macro did not; this caused failures even
though the subtable entries are valid.

Fixes: aeb823bbacc2 (ACPICA: ACPI 6.0: Add changes for FADT table.)
Signed-off-by: Al Stone <al.stone at linaro.org>
Reviewed-by: Hanjun Guo <hanjun.guo at linaro.org>
Acked-by: Will Deacon <will.deacon at arm.com>
---
 arch/arm64/kernel/smp.c   | 2 +-
 drivers/irqchip/irq-gic.c | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/kernel/smp.c b/arch/arm64/kernel/smp.c
index a1883bf..25fc88c 100644
--- a/arch/arm64/kernel/smp.c
+++ b/arch/arm64/kernel/smp.c
@@ -438,7 +438,7 @@ acpi_parse_gic_cpu_interface(struct acpi_subtable_header *header,
 	struct acpi_madt_generic_interrupt *processor;
 
 	processor = (struct acpi_madt_generic_interrupt *)header;
-	if (BAD_MADT_ENTRY(processor, end))
+	if (BAD_MADT_GICC_ENTRY(processor, end))
 		return -EINVAL;
 
 	acpi_table_print_madt_entry(header);
diff --git a/drivers/irqchip/irq-gic.c b/drivers/irqchip/irq-gic.c
index 8d7e1c8..4dd8826 100644
--- a/drivers/irqchip/irq-gic.c
+++ b/drivers/irqchip/irq-gic.c
@@ -1055,7 +1055,7 @@ gic_acpi_parse_madt_cpu(struct acpi_subtable_header *header,
 
 	processor = (struct acpi_madt_generic_interrupt *)header;
 
-	if (BAD_MADT_ENTRY(processor, end))
+	if (BAD_MADT_GICC_ENTRY(processor, end))
 		return -EINVAL;
 
 	/*
-- 
2.4.3