[PATCH v2 0/4] Allow to use leds-ns2 with n090401 boards

[Simon Guinot]

Hello,

This patch series allows to use the leds-ns2 driver with the n090401
boards (Seagate NAS 4-Bay), based on an Armada-370 SoC.

Here is the list changes:

- Allow to configure the LED mode mapping.
- Handle can_sleep GPIOs. On n090401, the LEDs are connected to an I2C
  GPIO expander.
- Make leds-ns2 depends on MACH_ARMADA_370.

Changes for v2:
- Fix gpio_{get,set}_*_cansleep() usage while holding a spinlock:
  Holding a spinlock at this places was not needed.
- Add Acked-by from Jacek Anaszewski for patch 4.

Simon

Simon Guinot (2):
  leds: leds-ns2: handle can_sleep GPIOs
  leds: leds-ns2: depends on MACH_ARMADA_370

Vincent Donnefort (2):
  leds: leds-ns2: move LED modes mapping outside of the driver
  ARM: Kirkwood: add modes-map property to ns2-leds nodes

 .../devicetree/bindings/leds/leds-ns2.txt          |   9 ++
 arch/arm/boot/dts/kirkwood-d2net.dts               |   5 +
 arch/arm/boot/dts/kirkwood-is2.dts                 |   5 +
 arch/arm/boot/dts/kirkwood-ns2.dts                 |   5 +
 arch/arm/boot/dts/kirkwood-ns2max.dts              |   5 +
 arch/arm/boot/dts/kirkwood-ns2mini.dts             |   5 +
 drivers/leds/Kconfig                               |  12 +-
 drivers/leds/leds-ns2.c                            | 169 ++++++++++++---------
 include/dt-bindings/leds/leds-ns2.h                |   8 +
 include/linux/platform_data/leds-kirkwood-ns2.h    |  14 ++
 10 files changed, 165 insertions(+), 72 deletions(-)
 create mode 100644 include/dt-bindings/leds/leds-ns2.h

-- 
2.1.4