MUSB dual-role on AM335x behaving weirdly

[Gregory CLEMENT]

Hi Felipe,

On 27/05/2015 11:42, Alexandre Belloni wrote:
> Hi,
> 
> On 26/05/2015 at 09:51:18 -0500, Felipe Balbi wrote :
>> On Thu, May 14, 2015 at 04:36:33PM -0500, Bin Liu wrote:
>>> Alexandre,
>>>
>>> On Thu, May 14, 2015 at 4:26 PM, Alexandre Belloni
>>> <alexandre.belloni at free-electrons.com> wrote:
>>>> On 14/05/2015 at 16:16:12 -0500, Bin Liu wrote :
>>>>> I think I found the root cause of the problem: board design issue - I
>>>>> bet the custom board has too much cap on VBUS line. It should be <
>>>>> 10uF.
>>>>>
>>>>
>>>> We have a custom board that exhibits the issue but it only has a 100nF
>>>> cap on VBUS.
>>>
>>> Have you measured the VBUS discharging? Is there any way to share your
>>> schematics?
>>
>> Alexandre, any further comments ?
>>
> 
> Yeah, I have just got more info.
> 
> This is the relevant part of the schematic:
> http://free-electrons.com/~alexandre/usb.png
> 
> The total VBUS capacitance is 200nF and the USB0 pins are connected
> directly to the AM3358 pins. U1 is actually not fitted.
> 
> We didn't measure VBUS discharging but we observe the OTG pin sensing
> stops when plugging an OTG cable without any device.

Do you have any news about this topic?


Is there something else that we can do to help solving this issue?


Thanks,

Gregory


-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com