[PATCH v3 2/5] PCI: designware: Add ARM64 support

[Zhou Wang]

On 2015/7/2 1:32, James Morse wrote:
> Gabriele Paoloni wrote:
>>> Both series are applied to v4.1, use the same .config file, and the
>>> same dtb.
>>> I will investigate further.
>>>
>>> (Re-testing v2 works, so this isn't an interim hardware failure)
>>
>> This is a bit weird....
>>
>> Patch 2/5 is the only one that affect platforms different from Hisilicon
>>
>> The only difference between V3 patch[2/5] and v2 patch[2/4] is
> 
> Between v3:2/5 and your replacement for v2:2/4, which arrived after I had
> tested the v2 series. As the patch has been replaced with a different one -
> neither 'tested-by' is true any more.
>

Hi James,

Firstly, many thanks for your test!

Yes. v3:2/5 had merged Gabriele's codes in. So if you made test on original
v2 patchset and v3 patchset, I think the differences include Gabriele's codes
and codes in pci-keystone-dw.c.

As the patch has been replaced with a different one, I think I should have
added 'tested-by' after it passes your test, is this right?

> It looks like the BAR containing the bridge window is not being assigned,
> so no devices on bus 1 are discovered.
> 
> I will send the full v2 and v3 dmesg output separately.
> 

Thanks, I will debug the problem according your log.

Regards,
Zhou

> 
> Thanks,
> 
> James
> 
> 
> .
>