[PATCH V2] clk: mxs: Fix invalid 32-bit access to frac registers

[Stefan Wahren]

Hi,

Am 28.01.2015 um 17:10 schrieb Zhi Li:
> On Wed, Jan 28, 2015 at 9:52 AM, Stefan Wahren <stefan.wahren at i2se.com> wrote:
>> Hi,
>>
>> Am 28.01.2015 um 04:36 schrieb Zhi Li:
>>> On Tue, Jan 27, 2015 at 7:51 PM, Mike Turquette <mturquette at linaro.org> wrote:
>>>> Quoting Marek Vasut (2015-01-21 15:39:01)
>>>>> On Wednesday, January 21, 2015 at 05:16:03 PM, Zhi Li wrote:
>>>>>> On Sun, Dec 28, 2014 at 4:26 AM, Stefan Wahren <stefan.wahren at i2se.com> wrote:
>>>>>>> According to i.MX23 and i.MX28 reference manual the fractional
>>>>>>> clock control registers must be addressed by byte instructions.
>>>>>> I don't think mx23 and mx28 have such limitation. I will double check
>>>>>> with IC team about this.
>>>>>> RTL is generated from a xml file. All registers implement is unified.
>>>>>> I don't think only clock control register have such limitation and
>>>>>> other registers not.
>>>>> Hi,
>>>>>
>>>>> Section 10.8.24 in the MX28 datasheet (Fractional Clock Control Register 0)
>>>>> states otherwise, but maybe the documentation is simply not matching the
>>>>> silicon.
>>>>>
>>>>> Here's a quote:
>>>>> "
>>>>> This register controls the 9-phase fractional clock dividers. The fractional
>>>>> clock frequencies are a product of the values in these registers. NOTE: This
>>>>> register can only be addressed by byte instructions. Addressing word or half-
>>>>> word are not allowed.
>>>>> "
>>>>>
>>>>> I also recall seeing weird behavior when these registers were accessed by word
>>>>> access in U-Boot, so I believe the datasheet is correct.
>>>> Hi Frank,
>>>>
>>>> Are you satisfied with this patch?
>>> I asked IC designer about this.
>>> They will check RTL code.
>>> I will check their status again.
>>> Our released BSP code used 32bit WORD access.
>> i want to point out that the 32bit WORD is divided in 4 parts (IO0FRAC,
>> IO1FRAC, EMIFRAC, CPUFRAC). Yes, it's true that BSP code access the
>> register as 32bit, but it's never modify the complete 32bit at once just
>> only 1 part (8bit) at a time.
>>
>> So here is my theory about Fractional Clock Control Register:
>>
>> Reading as 32bit WORD => safe
>> Modify only 1 part (8bit) of the 32bit WORD => safe
>> Modify more than 1 part of the 32bit WORD => unsafe !!!
> Yes, it is align with what I get from IC designer.
>
> best regards
> Frank Li

okay, fine. The clk init for the i.MX28 in the kernel tries to the set
IO0FRAC and IO1FRAC at once. So this patch fix this problem.

And since i was on that, i changed all accesses on that register to 8bit
to avoid this problem in the future.

So what's your opinion about this patch?

Best regards
Stefan

>
>> Best regards
>> Stefan
>>
>>> best regards
>>> Frank Li
>>>> Regards,
>>>> Mike
>>>>
>>>>> Best regards,
>>>>> Marek Vasut
>>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel