[PATCH v2 09/12] ARM: dts: apq8064: Add USB OTG support for CM QS-600

[Stephen Boyd]

On 04/10/15 05:34, Srinivas Kandagatla wrote:
> From: Nicolas Dechesne <nicolas.dechesne at linaro.org>
>
> This patch adds USB OTG support on USB1 for Compulab QS-600 Board.
>
> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
> [Srinivas Kandagatla: fixed up regulators and status properties]
> Signed-off-by: Nicolas Dechesne <nicolas.dechesne at linaro.org>
> ---
>  arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 17 +++++++++++++++++
>  1 file changed, 17 insertions(+)
>
> diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
> index fc69931..d353694 100644
> --- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
> +++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
> @@ -101,6 +101,14 @@
>  			};
>  		};
>  
> +		/* OTG */
> +		usb1_phy:phy at 12500000 {

Space after that ':' please.

> +			status		= "okay";
> +			vddcx-supply	= <&pm8921_s3>;
> +			v3p3-supply	= <&pm8921_l3>;
> +			v1p8-supply	= <&pm8921_l4>;
> +		};
> +
>  		usb3_phy:phy at 12520000 {
>  			status		= "okay";
>  			vddcx-supply	= <&pm8921_s3>;
> @@ -115,6 +123,15 @@
>  			v1p8-supply	= <&pm8921_l23>;
>  		};
>  
> +		gadget1:gadget at 12500000 {
> +			status = "ok";
> +		};
> +
> +		/* OTG */
> +		usb1: usb at 12500000 {

This one is good.

> +			status = "ok";
> +		};
> +
>  		usb3: usb at 12520000 {
>  			status = "okay";
>  		};


-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project