[PATCH v2 09/12] ARM: dts: apq8064: Add USB OTG support for CM QS-600

[Srinivas Kandagatla]

From: Nicolas Dechesne <nicolas.dechesne at linaro.org>

This patch adds USB OTG support on USB1 for Compulab QS-600 Board.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
[Srinivas Kandagatla: fixed up regulators and status properties]
Signed-off-by: Nicolas Dechesne <nicolas.dechesne at linaro.org>
---
 arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
index fc69931..d353694 100644
--- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
@@ -101,6 +101,14 @@
 			};
 		};
 
+		/* OTG */
+		usb1_phy:phy at 12500000 {
+			status		= "okay";
+			vddcx-supply	= <&pm8921_s3>;
+			v3p3-supply	= <&pm8921_l3>;
+			v1p8-supply	= <&pm8921_l4>;
+		};
+
 		usb3_phy:phy at 12520000 {
 			status		= "okay";
 			vddcx-supply	= <&pm8921_s3>;
@@ -115,6 +123,15 @@
 			v1p8-supply	= <&pm8921_l23>;
 		};
 
+		gadget1:gadget at 12500000 {
+			status = "ok";
+		};
+
+		/* OTG */
+		usb1: usb at 12500000 {
+			status = "ok";
+		};
+
 		usb3: usb at 12520000 {
 			status = "okay";
 		};
-- 
1.9.1