[PATCH V2 1/3] mmc: dw_mmc: use mmc_regulator_get_supply to handle regulators
Bartlomiej Zolnierkiewicz
b.zolnierkie at samsung.com
Wed Oct 1 07:14:32 PDT 2014
On Wednesday, October 01, 2014 03:57:54 PM Bartlomiej Zolnierkiewicz wrote:
>
> Hi,
>
> On Tuesday, September 30, 2014 02:23:44 PM Jaehoon Chung wrote:
> > Hi
> >
> > On 09/29/2014 09:31 PM, Bartlomiej Zolnierkiewicz wrote:
> > >
> > > Hi,
> > >
> > > On Friday, August 29, 2014 01:34:44 PM Ulf Hansson wrote:
> > >> On 22 August 2014 15:47, Yuvaraj Kumar C D <yuvaraj.cd at gmail.com> wrote:
> > >>> This patch makes use of mmc_regulator_get_supply() to handle
> > >>> the vmmc and vqmmc regulators.Also it moves the code handling
> > >>> the these regulators to dw_mci_set_ios().It turned on the vmmc
> > >>> and vqmmc during MMC_POWER_UP and MMC_POWER_ON,and turned off
> > >>> during MMC_POWER_OFF.
> > >>>
> > >>> Signed-off-by: Yuvaraj Kumar C D <yuvaraj.cd at samsung.com>
> > >>
> > >> Thanks! Applied for next.
> > >
> > > Unfortunately this patch breaks mmc1 card (Kingston 32GB micro SDHC)
> > > detection on Exynos5420 Arndale Octa for me:
> > >
> > > [ 10.797979] dwmmc_exynos 12220000.mmc: no support for card's volts
> > > [ 10.797998] mmc1: error -22 whilst initialising SD card
> >
> > OCR value is not matched. Which values are supported about the mmc_host's value and card's value?
> > Could you share the value?
>
> Sure. I've added dev_info()s at the beginning of mmc_select_voltage():
>
> + dev_warn(mmc_dev(host), "card's volts: 0x%0x\n", ocr);
> + dev_warn(mmc_dev(host), "host's volts: 0x%0x\n", host->ocr_avail);
>
> and got following results:
>
> [ 10.851678] dwmmc_exynos 12220000.mmc: card's volts: 0xff8000
> [ 10.851691] dwmmc_exynos 12220000.mmc: host's volts: 0x80
Data for the working kernel:
[ 10.856214] dwmmc_exynos 12220000.mmc: card's volts: 0xff8000
[ 10.856227] dwmmc_exynos 12220000.mmc: host's volts: 0x300000
Best regards,
--
Bartlomiej Zolnierkiewicz
Samsung R&D Institute Poland
Samsung Electronics
> Best regards,
> --
> Bartlomiej Zolnierkiewicz
> Samsung R&D Institute Poland
> Samsung Electronics
>
> > Best Regards,
> > Jaehoon Chung
> >
> > >
> > > Without the patch:
> > >
> > > [ 10.866926] mmc_host mmc1: Bus speed (slot 0) = 50000000Hz (slot req 50000000Hz, actual 50000000HZ div = 0)
> > > [ 10.866977] mmc1: new high speed SDHC card at address 1234
> > > [ 10.868730] mmcblk1: mmc1:1234 SA32G 29.3 GiB
> > > [ 10.915054] mmcblk1: p1 p2 p3
> > >
> > > The config is attached (exynos_defconfig doesn't work correctly for
> > > this board yet).
> > >
> > > Best regards,
> > > --
> > > Bartlomiej Zolnierkiewicz
> > > Samsung R&D Institute Poland
> > > Samsung Electronics
> > >
> > >> Kind regards
> > >> Uffe
> > >>
> > >>> ---
> > >>> changes from v1:
> > >>> 1.Used mmc_regulator_set_ocr() instead of regulator_enable() for vmmc.
> > >>> 2.Turned on vmmc and vqmmc during MMC_POWER_UP.
> > >>> 3. Removed the flags DW_MMC_CARD_POWERED and DW_MMC_IO_POWERED which
> > >>> added during the initial version of this patch.
> > >>> 4. Added error message, if it failed to turn on regulator's.
> > >>>
> > >>> drivers/mmc/host/dw_mmc.c | 72 +++++++++++++++++++++-----------------------
> > >>> include/linux/mmc/dw_mmc.h | 2 +-
> > >>> 2 files changed, 36 insertions(+), 38 deletions(-)
> > >>>
> > >>> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
> > >>> index 7f227e9..aadb0d6 100644
> > >>> --- a/drivers/mmc/host/dw_mmc.c
> > >>> +++ b/drivers/mmc/host/dw_mmc.c
> > >>> @@ -936,6 +936,7 @@ static void dw_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
> > >>> struct dw_mci_slot *slot = mmc_priv(mmc);
> > >>> const struct dw_mci_drv_data *drv_data = slot->host->drv_data;
> > >>> u32 regs;
> > >>> + int ret;
> > >>>
> > >>> switch (ios->bus_width) {
> > >>> case MMC_BUS_WIDTH_4:
> > >>> @@ -974,12 +975,38 @@ static void dw_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
> > >>>
> > >>> switch (ios->power_mode) {
> > >>> case MMC_POWER_UP:
> > >>> + if (!IS_ERR(mmc->supply.vmmc)) {
> > >>> + ret = mmc_regulator_set_ocr(mmc, mmc->supply.vmmc,
> > >>> + ios->vdd);
> > >>> + if (ret) {
> > >>> + dev_err(slot->host->dev,
> > >>> + "failed to enable vmmc regulator\n");
> > >>> + /*return, if failed turn on vmmc*/
> > >>> + return;
> > >>> + }
> > >>> + }
> > >>> + if (!IS_ERR(mmc->supply.vqmmc) && !slot->host->vqmmc_enabled) {
> > >>> + ret = regulator_enable(mmc->supply.vqmmc);
> > >>> + if (ret < 0)
> > >>> + dev_err(slot->host->dev,
> > >>> + "failed to enable vqmmc regulator\n");
> > >>> + else
> > >>> + slot->host->vqmmc_enabled = true;
> > >>> + }
> > >>> set_bit(DW_MMC_CARD_NEED_INIT, &slot->flags);
> > >>> regs = mci_readl(slot->host, PWREN);
> > >>> regs |= (1 << slot->id);
> > >>> mci_writel(slot->host, PWREN, regs);
> > >>> break;
> > >>> case MMC_POWER_OFF:
> > >>> + if (!IS_ERR(mmc->supply.vmmc))
> > >>> + mmc_regulator_set_ocr(mmc, mmc->supply.vmmc, 0);
> > >>> +
> > >>> + if (!IS_ERR(mmc->supply.vqmmc) && slot->host->vqmmc_enabled) {
> > >>> + regulator_disable(mmc->supply.vqmmc);
> > >>> + slot->host->vqmmc_enabled = false;
> > >>> + }
> > >>> +
> > >>> regs = mci_readl(slot->host, PWREN);
> > >>> regs &= ~(1 << slot->id);
> > >>> mci_writel(slot->host, PWREN, regs);
> > >>> @@ -2110,7 +2137,13 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id)
> > >>> mmc->f_max = freq[1];
> > >>> }
> > >>>
> > >>> - mmc->ocr_avail = MMC_VDD_32_33 | MMC_VDD_33_34;
> > >>> + /*if there are external regulators, get them*/
> > >>> + ret = mmc_regulator_get_supply(mmc);
> > >>> + if (ret == -EPROBE_DEFER)
> > >>> + goto err_setup_bus;
> > >>> +
> > >>> + if (!mmc->ocr_avail)
> > >>> + mmc->ocr_avail = MMC_VDD_32_33 | MMC_VDD_33_34;
> > >>>
> > >>> if (host->pdata->caps)
> > >>> mmc->caps = host->pdata->caps;
> > >>> @@ -2176,7 +2209,7 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id)
> > >>>
> > >>> err_setup_bus:
> > >>> mmc_free_host(mmc);
> > >>> - return -EINVAL;
> > >>> + return ret;
> > >>> }
> > >>>
> > >>> static void dw_mci_cleanup_slot(struct dw_mci_slot *slot, unsigned int id)
> > >>> @@ -2469,24 +2502,6 @@ int dw_mci_probe(struct dw_mci *host)
> > >>> }
> > >>> }
> > >>>
> > >>> - host->vmmc = devm_regulator_get_optional(host->dev, "vmmc");
> > >>> - if (IS_ERR(host->vmmc)) {
> > >>> - ret = PTR_ERR(host->vmmc);
> > >>> - if (ret == -EPROBE_DEFER)
> > >>> - goto err_clk_ciu;
> > >>> -
> > >>> - dev_info(host->dev, "no vmmc regulator found: %d\n", ret);
> > >>> - host->vmmc = NULL;
> > >>> - } else {
> > >>> - ret = regulator_enable(host->vmmc);
> > >>> - if (ret) {
> > >>> - if (ret != -EPROBE_DEFER)
> > >>> - dev_err(host->dev,
> > >>> - "regulator_enable fail: %d\n", ret);
> > >>> - goto err_clk_ciu;
> > >>> - }
> > >>> - }
> > >>> -
> > >>> host->quirks = host->pdata->quirks;
> > >>>
> > >>> spin_lock_init(&host->lock);
> > >>> @@ -2630,8 +2645,6 @@ err_workqueue:
> > >>> err_dmaunmap:
> > >>> if (host->use_dma && host->dma_ops->exit)
> > >>> host->dma_ops->exit(host);
> > >>> - if (host->vmmc)
> > >>> - regulator_disable(host->vmmc);
> > >>>
> > >>> err_clk_ciu:
> > >>> if (!IS_ERR(host->ciu_clk))
> > >>> @@ -2667,9 +2680,6 @@ void dw_mci_remove(struct dw_mci *host)
> > >>> if (host->use_dma && host->dma_ops->exit)
> > >>> host->dma_ops->exit(host);
> > >>>
> > >>> - if (host->vmmc)
> > >>> - regulator_disable(host->vmmc);
> > >>> -
> > >>> if (!IS_ERR(host->ciu_clk))
> > >>> clk_disable_unprepare(host->ciu_clk);
> > >>>
> > >>> @@ -2686,9 +2696,6 @@ EXPORT_SYMBOL(dw_mci_remove);
> > >>> */
> > >>> int dw_mci_suspend(struct dw_mci *host)
> > >>> {
> > >>> - if (host->vmmc)
> > >>> - regulator_disable(host->vmmc);
> > >>> -
> > >>> return 0;
> > >>> }
> > >>> EXPORT_SYMBOL(dw_mci_suspend);
> > >>> @@ -2697,15 +2704,6 @@ int dw_mci_resume(struct dw_mci *host)
> > >>> {
> > >>> int i, ret;
> > >>>
> > >>> - if (host->vmmc) {
> > >>> - ret = regulator_enable(host->vmmc);
> > >>> - if (ret) {
> > >>> - dev_err(host->dev,
> > >>> - "failed to enable regulator: %d\n", ret);
> > >>> - return ret;
> > >>> - }
> > >>> - }
> > >>> -
> > >>> if (!dw_mci_ctrl_reset(host, SDMMC_CTRL_ALL_RESET_FLAGS)) {
> > >>> ret = -ENODEV;
> > >>> return ret;
> > >>> diff --git a/include/linux/mmc/dw_mmc.h b/include/linux/mmc/dw_mmc.h
> > >>> index 29ce014..84e2827 100644
> > >>> --- a/include/linux/mmc/dw_mmc.h
> > >>> +++ b/include/linux/mmc/dw_mmc.h
> > >>> @@ -188,7 +188,7 @@ struct dw_mci {
> > >>> /* Workaround flags */
> > >>> u32 quirks;
> > >>>
> > >>> - struct regulator *vmmc; /* Power regulator */
> > >>> + bool vqmmc_enabled;
> > >>> unsigned long irq_flags; /* IRQ flags */
> > >>> int irq;
> > >>> };
> > >>> --
> > >>> 1.7.10.4
More information about the linux-arm-kernel
mailing list