[PATCH] ARM: dts: duovero-parlor: Add HDMI output

[Florian Vaussard]

On 05/20/2014 04:39 PM, Tony Lindgren wrote:
> * Florian Vaussard <florian.vaussard at epfl.ch> [140520 07:26]:
>> @@ -77,6 +94,15 @@
>>  			0x30 (PIN_INPUT_PULLUP | MUX_MODE3)	/* gpmc_a24.gpio_48: amdix enabled */
>>  		>;
>>  	};
>> +
>> +	dss_hdmi_pins: pinmux_dss_hdmi_pins {
>> +		pinctrl-single,pins = <
>> +			0x58 (PIN_INPUT_PULLUP | MUX_MODE0)	/* hdmi_hpd.hdmi_hpd */
>> +			0x5a (PIN_INPUT_PULLUP | MUX_MODE0)	/* hdmi_cec.hdmi_cec */
>> +			0x5c (PIN_INPUT_PULLUP | MUX_MODE0)	/* hdmi_ddc_scl.hdmi_ddc_scl */
>> +			0x5e (PIN_INPUT_PULLUP | MUX_MODE0)	/* hdmi_ddc_sda.hdmi_ddc_sda */
>> +		>;
>> +	};
>>  };
>>  
>>  &i2c2 {
> 
> This seems to apply with fuzz against omap-for-v3.16/dt-v2, but
> should be updated against omap-for-v3.16/dt-v2 to use OMAP4_IOPAD
> as omap4-duovero-parlor.dts is now using it. That makes checking
> the muxing easier against the TRM. See commit 5efa994b0d49 for
> the script Joachim used.
> 

It is based on Tomi's for-next, which is based on 3.15-rc4, so the fuzz
is not surprising. I will update against omap-for-v3.16/dt-v2.

Regards,
Florian