[PATCH 3/4] OMAPDSS: panel-sharp-ls037v7dw01: add device tree support

[Tony Lindgren]

* Tomi Valkeinen <tomi.valkeinen at ti.com> [140509 01:31]:
> On 09/05/14 02:33, Tony Lindgren wrote:
> > * Tony Lindgren <tony at atomide.com> [140507 11:00]:
> >> * Tomi Valkeinen <tomi.valkeinen at ti.com> [140507 09:03]:
> >>> On 07/05/14 18:03, Tony Lindgren wrote:
> >>>>
> >>>> BTW, I'm also personally fine with all five gpios showing in a single
> >>>> gpios property, I'm not too exited about naming anything in DT..
> >>>
> >>> I don't have a strong opinion here. I don't have much experience with
> >>> DT, especially with making bindings compatible with other ones.
> >>>
> >>> I'd just forget the simple-panel, and have single gpio array.
> >>
> >> Well if it's a don't care flag for both of us, let's try to use
> >> the existing standard for simple-panel.txt and add mode-gpios
> >> property. I'll post a patch for that.
> > 
> > Here's an updated version using enable-gpios, reset-gpios and
> > mode-gpios. So it follows simple-panel.txt and adds mode-gpios
> > that's currently specific to this panel only.
> > 
> > Also updated for -EPROBE_DEFER handling, tested that by changing
> > one of the GPIOs to be a twl4030 GPIO.
> 
> To speed things up a bit, I made the changes I suggested. Compile tested
> only.

OK thanks did not get the penguin with it so need to look at it a bit
more.

Regards,

Tony