mx6qsabresd hangs on linux-next

[Maxime Coquelin]

Hi Fabio,

On 05/07/2014 04:39 PM, Fabio Estevam wrote:
> Hi Maxime,
>
> On Wed, May 7, 2014 at 5:32 AM, Maxime Coquelin <maxime.coquelin at st.com> wrote:
>
>> You are right. Sorry for the regression.
>>
>> I thought I tested it, as I had some table-based dividers in my test setup.
>> After checking again, it appears that I didn't had the CLK_SET_RATE_PARENT
>> flag set on these clocks, so I didn't entered the for loop...
>>
>> Could the fix be to initialize "up" variable to INT_MAX in _round_up_table
>> (see below)?
>
> This works fine for me:
>
> Tested-by: Fabio Estevam <fabio.estevam at freescale.com>
>
>> I can send the patch if you are fine with it.
>> I have no hardware to test on this week, I only have compiled this patch,
>> not tested it.
>
> Please submit your patch, thanks.
Thanks for testing it, patch sent.

Regards,
Maxime

>