mx6qsabresd hangs on linux-next

[Fabio Estevam]

Hi Maxime,

On Wed, May 7, 2014 at 5:32 AM, Maxime Coquelin <maxime.coquelin at st.com> wrote:

> You are right. Sorry for the regression.
>
> I thought I tested it, as I had some table-based dividers in my test setup.
> After checking again, it appears that I didn't had the CLK_SET_RATE_PARENT
> flag set on these clocks, so I didn't entered the for loop...
>
> Could the fix be to initialize "up" variable to INT_MAX in _round_up_table
> (see below)?

This works fine for me:

Tested-by: Fabio Estevam <fabio.estevam at freescale.com>

> I can send the patch if you are fine with it.
> I have no hardware to test on this week, I only have compiled this patch,
> not tested it.

Please submit your patch, thanks.