[PATCH v10 15/15] ARM: dts: sun7i: Add basic support for the Cubietruck WiFi module

[Maxime Ripard]

On Mon, May 05, 2014 at 12:20:56PM +0800, Chen-Yu Tsai wrote:
> On Mon, May 5, 2014 at 12:02 PM, Maxime Ripard
> <maxime.ripard at free-electrons.com> wrote:
> > On Fri, May 02, 2014 at 05:57:29PM +0200, Hans de Goede wrote:
> >> From: Chen-Yu Tsai <wens at csie.org>
> >>
> >> The CubieTruck has an AMPAK AP6210 WiFi+Bluetooth module. The WiFi
> >> part is a BCM43362 IC connected to MMC3 in the A20 SoC via SDIO.
> >> The IC also takes a power enable signal via GPIO.
> >>
> >> The WiFi module supports out-of-band interrupt signaling via GPIO,
> >> but this is not supported in this patch.
> >>
> >> Signed-off-by: Hans de Goede <hdegoede at redhat.com>
> >
> > It doesn't have Chen-Yu SoB. Chen-Yu, are you fine with adding it?
> 
> My apologies, I didn't notice this patch still had my name on it.
> Looks good.
> 
> Signed-off-by: Chen-Yu Tsai <wens at csie.org>
> (or Acked-by, not sure which applies in this situation.)

Since you're the author, we need your SoB.

If you were not involved with writing (or merging the patch), Acked-by
would have been appropriate.

Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: Digital signature
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20140505/a840a814/attachment.sig>