[PATCH v10 15/15] ARM: dts: sun7i: Add basic support for the Cubietruck WiFi module

[Chen-Yu Tsai]

On Mon, May 5, 2014 at 12:02 PM, Maxime Ripard
<maxime.ripard at free-electrons.com> wrote:
> On Fri, May 02, 2014 at 05:57:29PM +0200, Hans de Goede wrote:
>> From: Chen-Yu Tsai <wens at csie.org>
>>
>> The CubieTruck has an AMPAK AP6210 WiFi+Bluetooth module. The WiFi
>> part is a BCM43362 IC connected to MMC3 in the A20 SoC via SDIO.
>> The IC also takes a power enable signal via GPIO.
>>
>> The WiFi module supports out-of-band interrupt signaling via GPIO,
>> but this is not supported in this patch.
>>
>> Signed-off-by: Hans de Goede <hdegoede at redhat.com>
>
> It doesn't have Chen-Yu SoB. Chen-Yu, are you fine with adding it?

My apologies, I didn't notice this patch still had my name on it.
Looks good.

Signed-off-by: Chen-Yu Tsai <wens at csie.org>
(or Acked-by, not sure which applies in this situation.)

> No need to respin the set, I'll add it when applying if it's ok.

Thanks!


Cheers,
ChenYu