[PATCH 6/6] tty: serial: Add 8250-core based omap driver

[Sekhar Nori]

On Wednesday 16 July 2014 06:02 PM, Tony Lindgren wrote:
> * Sebastian Andrzej Siewior <bigeasy at linutronix.de> [140716 05:14]:
>> On 07/11/2014 08:41 AM, Tony Lindgren wrote:
>>>
>>> If the RX pin does not wake it up, you need to configure the
>>> pinctrl-single entry for it, and configure that pin as a wake-up
>>> interrupt. See the interrupts-extended entry in omap3-beagle-xm.dts.
>>
>> This does not help. Checking the manual, there is not something like
>> PIN_OFF_WAKEUPENABLE for am33xx. There is just INPUT/OUTPUT, pull
>> up/down + enabled/disabled and the mux_mode. For the interrupt, the HW
>> referenced as omap3_pmx_core touches some bits in the pinmux register
>> which do not exists on am33xx.
> 
> Right, on am33xx there's no IO chain wake-up path. AFAIK the only way
> to provide wake events on am33xx would be to mux the RX pin temporarily
> to a GPIO input. And sounds like that may work only if the GPIO is
> in the first GPIO bank that's always on. I don't know if the other
> GPIO banks on am33xx can provide wake up events.

No, they cannot.

Thanks,
Sekhar