[PATCH 6/6] tty: serial: Add 8250-core based omap driver

[Tony Lindgren]

* Sebastian Andrzej Siewior <bigeasy at linutronix.de> [140716 05:14]:
> On 07/11/2014 08:41 AM, Tony Lindgren wrote:
> > 
> > If the RX pin does not wake it up, you need to configure the
> > pinctrl-single entry for it, and configure that pin as a wake-up
> > interrupt. See the interrupts-extended entry in omap3-beagle-xm.dts.
> 
> This does not help. Checking the manual, there is not something like
> PIN_OFF_WAKEUPENABLE for am33xx. There is just INPUT/OUTPUT, pull
> up/down + enabled/disabled and the mux_mode. For the interrupt, the HW
> referenced as omap3_pmx_core touches some bits in the pinmux register
> which do not exists on am33xx.

Right, on am33xx there's no IO chain wake-up path. AFAIK the only way
to provide wake events on am33xx would be to mux the RX pin temporarily
to a GPIO input. And sounds like that may work only if the GPIO is
in the first GPIO bank that's always on. I don't know if the other
GPIO banks on am33xx can provide wake up events.
 
> So I have nothing on HW around that could test wakeup scenario.

Bummer :( I'll give it a try again for the next revision.

Regards,

Tony