[PATCH v4 00/10] Add SDHCI support for ST Microelectronics SoCs

Ulf Hansson ulf.hansson at linaro.org
Thu Jul 10 05:51:53 PDT 2014


On 9 July 2014 17:51, Maxime Coquelin <maxime.coquelin at st.com> wrote:
>
>
> On 07/09/2014 05:07 PM, Peter Griffin wrote:
>>
>> This series adds a SDHCI platform driver for ST SoCs, along with
>> the additional device tree bindings and configuration to enable
>> the controller to work properly.
>>
>> Initially it supports the stih416 and stih415 SoCs, and has
>> been tested on a stih416-b2020 board.
>>
>> regards,
>>
>> Peter.
>>
>> Changes since v1
>> - Whitespace cleanups
>> - Use readl_relaxed io accessor
>> - Add update to MAINTAINERS
>> - Remove reset controller code from platform driver
>> - Remove #ifdef around sleep ops
>> - Use sdhci_pltfm_clk_get_max_clock lib function
>> - Pass bus-width etc through board device tree node
>> - Remove unncessary header
>> - Remove / change some debug messages
>> - Remove final break from switch case
>>
>> Changes since v2
>> - Update CC list with alkml and lkml lists
>>
>> Changes since v3
>> - Rebased on v3.16-rc4
>> - Use sdhci_set_bus_width lib function for set_bus_width
>> - Remove sdhci_st_8bit_width function
>> - Use sdhci_set_clock lib function for set_clock
>>
>> Peter Griffin (10):
>>    mmc: sdhci-st: Intial support for ST SDHCI controller
>>    mmc: sdhci-st: ST Microelectronics SDHCI binding documentation.
>>    ARM: STi: DT: Add sdhci pins for stih416
>>    ARM: STi: DT: Add sdhci controller for stih416
>>    ARM: STi: DT: Add sdhci pin configuration for stih415
>>    ARM: STi: DT: Add sdhci controller for stih415
>>    ARM: STi: DT: Enable mmc0 for both stih415 and stih416 SoCs
>>    ARM: STi: DT: Enable second sdhci controller for stih416 b2020 boards.
>>    ARM: update multi_v7_defconfig for STI
>>    MAINTAINERS: Add sdhci-st file to ARCH/STI architecture
>>
>>   Documentation/devicetree/bindings/mmc/sdhci-st.txt |  33 ++++
>>   MAINTAINERS                                        |   1 +
>>   arch/arm/boot/dts/stih415-pinctrl.dtsi             |  21 +++
>>   arch/arm/boot/dts/stih415.dtsi                     |  12 ++
>>   arch/arm/boot/dts/stih416-b2020.dts                |   8 +
>>   arch/arm/boot/dts/stih416-b2020e.dts               |   6 +
>>   arch/arm/boot/dts/stih416-pinctrl.dtsi             |  39 +++++
>>   arch/arm/boot/dts/stih416.dtsi                     |  24 +++
>>   arch/arm/boot/dts/stih41x-b2020.dtsi               |   4 +
>>   arch/arm/boot/dts/stih41x-b2020x.dtsi              |   4 +
>>   arch/arm/configs/multi_v7_defconfig                |   1 +
>>   drivers/mmc/host/Kconfig                           |  12 ++
>>   drivers/mmc/host/Makefile                          |   1 +
>>   drivers/mmc/host/sdhci-st.c                        | 176
>> +++++++++++++++++++++
>>   14 files changed, 342 insertions(+)
>>   create mode 100644 Documentation/devicetree/bindings/mmc/sdhci-st.txt
>>   create mode 100644 drivers/mmc/host/sdhci-st.c
>>
>
> Thanks Peter.
>
> DT patches queued to git://git.stlinux.com/devel/kernel/linux-sti.git
> sti-dt-for-v3.17-1

What about patch9 and 10? Did you take them as well?

You may add my ack for them, for whatever it's worth.

Kind regards
Uffe

>
> Regards,
> Maxime



More information about the linux-arm-kernel mailing list