Freescale FEC packet loss

[Marek Vasut]

On Sunday, January 26, 2014 at 07:56:30 PM, Ben Hutchings wrote:
> On Wed, 2014-01-22 at 22:55 +0100, Marek Vasut wrote:
> > Hi guys,
> > 
> > I am running stock Linux 3.13 on i.MX6Q SabreLite board. The CPU is
> > i.MX6Q TO 1.0 .
> > 
> > I am hitting a WARNING when I use the FEC ethernet to transfer data, thus
> > I started investigating this problem. TL;DR I am not able to figure this
> > problem out, so I am not attaching a patch :-(
> > 
> > Steps to reproduce:
> > -------------------
> > 1) Boot stock Linux 3.13 on i.MX6Q SabreLite board
> > 2) Plug in an SD card into one of the SD slots (I use the full-size one)
> > 3) Plug in an USB stick into one of the USB ports (I use the upper one)
> > 4) Plug in an ethernet cable into the board
> > 
> >    -> Connect the other side into a gigabit-capable PC
> 
> [...]
> 
> I think there are known problems with 1000BASE-T on the Sabre Lite
> board.

This is MX6-wide thing, not sabrelite specific actually.

> Two possible workarounds are to limit the PHY to 100BASE-TX
> (should be doable with ethtool) or force it to be clock master for
> 1000BASE-T (requires a driver patch).

Can you please elaborate on the later ? I don't quite understand that.

> The vendor kernel apparently does both!

More like the vendor kernel papers over this bug.

> Matthew Garrett has been trying to implement a workaround in a
> clean way.

Do you have any pointers about this please ?

Best regards,
Marek Vasut