[PATCH 3/9] Doc/DT: Add DT binding documentation for DVI Connector

[Philipp Zabel]

Hi Tomi,

Am Freitag, den 28.02.2014, 14:20 +0200 schrieb Tomi Valkeinen:
> Add DT binding documentation for DVI Connector.
> 
> Signed-off-by: Tomi Valkeinen <tomi.valkeinen at ti.com>
> Reviewed-by: Archit Taneja <archit at ti.com>
> ---
>  .../devicetree/bindings/video/dvi-connector.txt    | 26 ++++++++++++++++++++++
>  1 file changed, 26 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/video/dvi-connector.txt
> 
> diff --git a/Documentation/devicetree/bindings/video/dvi-connector.txt b/Documentation/devicetree/bindings/video/dvi-connector.txt
> new file mode 100644
> index 000000000000..6a0aff866c78
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/video/dvi-connector.txt
> @@ -0,0 +1,26 @@
> +DVI Connector
> +==============
> +
> +Required properties:
> +- compatible: "dvi-connector"
> +
> +Optional properties:
> +- label: a symbolic name for the connector
> +- i2c-bus: phandle to the i2c bus that is connected to DVI DDC

For the i.MX bindings I had called this property 'ddc', but
Documentation/devicetree/bindings/panel/simple-panel.txt already
uses 'ddc-i2c-bus'. We should definitely standardize this.

> +Required nodes:
> +- Video port for DVI input
> +
> +Example
> +-------
> +
> +dvi0: connector at 0 {
> +	compatible = "dvi-connector";
> +	label = "dvi";
> +
> +	i2c-bus = <&i2c3>;
> +
> +	dvi_connector_in: endpoint {
> +		remote-endpoint = <&tfp410_out>;
> +	};
> +};

regards
Philipp