TWL6040 fails to initialize

[Peter Ujfalusi]

On 02/26/2014 11:53 AM, Florian Vaussard wrote:
> On 02/26/2014 08:26 AM, Peter Ujfalusi wrote:
>> On 02/25/2014 05:41 PM, Florian Vaussard wrote:
>>> If the power was not enabled at all, I would be unable to read the
>>> revision register, no? And delaying the probe by one millisecond would
>>> be of no help in this case IMHO.
>>
>> One thing which might cause this is that if the audpwron GPIO is set high
>> before the twl6040 module is probing. When I request the GPIO I ask it to be
>> set to low. If the line was high before this means we initiate the power off
>> sequence.
>> Can you try something like this:
>>
> 
> I statistically checked that the sleep should be placed after the GPIO
> request, so indeed this seems to be the problem, and your explanation is
> plausible. Can you send a proper patch?
> 
> Now, related to this, I managed to found a part of the datasheet on the
> Great Internet. Looking at the "Power-Up Sequence" section, it is written:
> 
> - NRESPWRON goes high -> plug detect and GPO are available
> - V2V1 goes high -> hook-detect available by I2C programming (sleep mode)
> - AUDPWRON goes high && READYINT -> ready to communicate through I2C and PDM
> 
> So, although there seems to be some contradictions on when it is
> possible to access the I2C, shouldn't we enable the AUDPWRON GPIO
> _before_ making any I2C access?
> 
> For the twl6040_probe, the following path would seem more correct to me:
> 
> 1) enable regulators
> 2) request AUDPWRON
> 3) twl6040_power(ON) && regcache_cache_only(false)
> 4) wait for READYINT (or sleep if deterministic)
> 5) perform all required I2C accesses (read revision, etc.)
> 6) twl6040_power(OFF) && regcache_cache_only(true)
> 
> What do you think?

Even when the AUDPWRON signal is low we can access to registers in VIO domain,
plug detect and GPO functions. So there's no need to power on the codec just
to power it down later.


> Thanks,
> Florian
> 
>> diff --git a/drivers/mfd/twl6040.c b/drivers/mfd/twl6040.c
>> index 75316fb33448..d2a0bd1539ae 100644
>> --- a/drivers/mfd/twl6040.c
>> +++ b/drivers/mfd/twl6040.c
>> @@ -674,6 +674,9 @@ static int twl6040_probe(struct i2c_client *client,
>>                                             GPIOF_OUT_INIT_LOW, "audpwron");
>>                 if (ret)
>>                         goto gpio_err;
>> +
>> +               /* power-down sequence latency */
>> +               usleep_range(500, 700);
>>         }
>>
>>         ret = regmap_add_irq_chip(twl6040->regmap, twl6040->irq, IRQF_ONESHOT,
>>
>>


-- 
Péter