[PATCH 2/2] regulator: core: Error on not always_on dummy regulators
Markus Pargmann
mpa at pengutronix.de
Tue Feb 25 05:03:47 EST 2014
It does not make sense to have dummy/fixed regulators that are not
always_on. This patch adds a check in the set_machine_constraints
function for this case and returns -EINVAL if such a regulator is
registered.
This also removes the return -EINVAL from _regulator_do_enable() if the
regulator can not be enabled.
Signed-off-by: Markus Pargmann <mpa at pengutronix.de>
---
drivers/regulator/core.c | 27 ++++++++++++++++++++++++---
1 file changed, 24 insertions(+), 3 deletions(-)
diff --git a/drivers/regulator/core.c b/drivers/regulator/core.c
index 6f71985..cb10faf 100644
--- a/drivers/regulator/core.c
+++ b/drivers/regulator/core.c
@@ -954,6 +954,7 @@ static int machine_constraints_current(struct regulator_dev *rdev,
}
static int _regulator_do_enable(struct regulator_dev *rdev);
+static bool regulator_can_enable(struct regulator_dev *rdev);
/**
* set_machine_constraints - sets regulator constraints
@@ -1012,12 +1013,19 @@ static int set_machine_constraints(struct regulator_dev *rdev,
}
}
+ if (!rdev->constraints->always_on && !regulator_can_enable(rdev))
+ {
+ rdev_err(rdev, "dummy regulator without always_on constraints is not valid\n");
+ ret = -EINVAL;
+ goto out;
+ }
+
/* If the constraints say the regulator should be on at this point
* and we have control then make sure it is enabled.
*/
if (rdev->constraints->always_on || rdev->constraints->boot_on) {
ret = _regulator_do_enable(rdev);
- if (ret < 0 && ret != -EINVAL) {
+ if (ret) {
rdev_err(rdev, "failed to enable\n");
goto out;
}
@@ -1739,6 +1747,21 @@ static int regulator_ena_gpio_ctrl(struct regulator_dev *rdev, bool enable)
return 0;
}
+/*
+ * Returns true if the regulator can be enabled through ops->enable or
+ * enable gpios.
+ */
+static bool regulator_can_enable(struct regulator_dev *rdev)
+{
+ if (rdev->desc->ops->enable)
+ return true;
+
+ if (rdev->ena_pin)
+ return true;
+
+ return false;
+}
+
static int _regulator_do_enable(struct regulator_dev *rdev)
{
int ret, delay;
@@ -1763,8 +1786,6 @@ static int _regulator_do_enable(struct regulator_dev *rdev)
ret = rdev->desc->ops->enable(rdev);
if (ret < 0)
return ret;
- } else {
- return -EINVAL;
}
/* Allow the regulator to ramp; it would be useful to extend
--
1.8.5.3
More information about the linux-arm-kernel
mailing list