[PATCH v5 00/35] mtd: st_spi_fsm: Add new driver
Lee Jones
lee.jones at linaro.org
Tue Feb 18 09:55:27 EST 2014
This should be the final version.
Version 5:
Tended to Christophe, Ludovic and Angus' comments.
Version 4:
Tended to Brian's review comments
- Checkpatch acceptance
- MODULE_DEVICE_TABLE() name slip correction
- Timeout issue(s) resolved
- Potential infinite loop mitigated
- Code clarity suggests heeded
- Duplication with MTD core code removed
- Upgraded to using ROUND_UP() helper
- Moved non-shared header code into main driver
- Relocated dynamic msg sequence stores into main struct
- Averted adaption of static (table) data
- Basic whitespace/spelling/data type/dev_err suggestions applied
Version 3:
Okay, this thing should be fully functional now. Identify a chip
based on it's JEDEC ID, Read, Write, Erase (all or by sector).
Support for various chip quirks added too.
Version 2:
The first bunch of these patches have been on the MLs before, but
didn't receive a great deal of attention for the most part. We are
a little more featureful this time however. We can now successfully
setup and configure the N25Q256. We still can't read/write/erase
it though. I'll start work on that next week and will provide it in
the next instalment.
Version 1:
First stab at getting this thing Mainlined. It doesn't do a great deal
yet, but we are able to initialise the device and dynamically set it up
correctly based on an extracted JEDEC ID.
Documentation/devicetree/bindings/mtd/st-fsm.txt | 26 ++
arch/arm/boot/dts/stih416-b2105.dts | 14 +
arch/arm/boot/dts/stih416-pinctrl.dtsi | 12 +
drivers/mtd/devices/Kconfig | 8 +
drivers/mtd/devices/Makefile | 1 +
drivers/mtd/devices/serial_flash_cmds.h | 81 +++++
drivers/mtd/devices/st_spi_fsm.c | 2122 ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
7 files changed, 2264 insertions(+)
More information about the linux-arm-kernel
mailing list